Nebula TES-ib2 Instruction Manual - page 5
Connecting the Cooktop to the Mains Power Supply
Important!
This cooktop must be connected to the mains power supply only by a
suitably qualified person
.
Before connecting the cooktop to the mains power supply
check that
,
:
The domestic wiring system is suitable for the power drawn by
the cooktop.
The voltage and power values listed on the data plate are
compatible with the electricity supply and socket. If you have any
doubts, please consult a qualified electrician for assistance.
To connect the cooktop to the mains power supply
do not use
,
adapters
reducers
or branching devices
as they can cause
,
,
,
overheating and fire
.
The power supply cable must not touch any hot parts and must be
positioned so that its temperature will not exceed 75
at any point
℃
.
Power Supply:
Important!
Check with an electrician whether the domestic wiring system is
The positioning must allow a fresh air intake and an air outlet of 5
mm minimum(See Fig. 3)
The benchtop is made of a heat- resistant material.And no
structural members interfere with space requirements.
The cooktop will not be installed directly above an appliance such
as dishwasher, fridge, freezer, washing machine, as the humidity
may damage the cooktop electronics.
If a built- in oven or any other appliance that generates heat must
be fitted directly under the glass ceramic cooktop, THIS APPLIANCE
(oven) AND THE GLASS-CERAMIC COOKTOP MUST BE SUITABLY
INSULATED in such a way that the heat generated by the oven,
measured on the bottom right of the cooktop, does not exceed 60°C.
A suitable isolating switch providing full disconnection from the
mains power supply is incorporated in the permanent wiring
mounted
,
and positioned to comply with the local wiring rules and regulations
.
The power supply cable is not accessible through cupboard doors
or drawers.
If the lower part of the appliance, after installation, is accessible
via the lower part of the cabinet then it is necessary to mount a
thermal protection barrier respecting the distances indicated ( See
Fig. 4) .
min55
650
(minimum clearance from glass
surface to rangehood)
Unit:mm
Fig:2
Fig:4
The thermal protection barrier
must be:
Removable
heat- resistant
made from low thermal conductivity
material
at least 25 mm below the plastic
housing of the cooktop chassis
Thermal protection barrier
vatilation
min.25
min.20
min.5
min.25
oven
min.20
min.5
Thermal protection barrier
cupboard or drawer
space below
Fig:3