Nebula TESHC03E Installation Instructions And User Manual

Manual is about: Induction & Electric Cooktop

Summary of TESHC03E

  • Page 1

    1 teshc03e induction& electric cooktop installation instructions and user guide contents 1. safety and warnings 2. installation instructions 3. introduction 4. using your cooktop 5. choosing the right cookware 6. cooking guidelines 7. care and cleaning 8. troubleshooting 9. warranty and service impo...

  • Page 2

    3 health hazard this appliance complies with electromagnetic safety standards. However, persons with cardiac pacemakers or other electrical implants (such as insulin pumps) must consult with their doctor or implant manufacturer before using this appliance to make sure that their implants will not be...

  • Page 3

    5 installation instructions z turn the cooktop upside down and place it on a soft surface. Z spread the seal around the edges of the ceramic glass with the adhesive side facing down, making sure that the whole perimeter is sealed. Cut off any excess material. Z place the cooktop into the cutout, usi...

  • Page 4

    7 a minimum clearance from rear edge of cutout to nearest combustible surface: 55 b minimum clearance from glass surface to rangehood: 650 c minimum clearance from side edges of cutout to nearest combustible surface: 80 d minimum clearance from benchtop to overhead cabinet not directly above the coo...

  • Page 5

    9 alterations. Any alterations must only be made by a qualified electrician. Connection diagrams single-phase connection 220-240v~ two-phase connection 380-415v 2n~ three-phase connection 380-415v 3n~ connecting the cooktop to the mains power supply connection diagrams final checklist to be complete...

  • Page 6

    11 4. Use is safer as no heating takes place unless a suitable pan is placed on the cooking zone. 5. As heat is transferred without loss, you save energy. Before using your new cooktop z read this guide, taking special note of the ‘safety and warnings’ section. Z remove any protective film that may ...

  • Page 7

    13 z adjust heating power sliding touch the power and timer setting range to increase or decrease the heating power. Z setting timer touching timer display to set timer for selected cooking zone. Z adjust timer setting sliding touch the power and timer setting range, or touch to increase or decrease...

  • Page 8

    15 important : 1. When the power to the cooktop is switched off, there will be no ‘hot surface’ indication but the cooking zone may still be hot! Take extreme care. 2. Heavy-duty scourers, some nylon scourers and harsh/abrasive cleaning agents may scratch the glass. Always read the label to check if...

  • Page 9

    17 ¾ problem: the touch controls are unresponsive. Possible causes the controls are locked. What to do unlock the controls. See section ‘using your induction cooktop’ for instructions. ¾ problem: the touch controls are difficult to operate. Possible causes there may be a slight film of water over th...

  • Page 10

    19 allow the cooktop to cool down. ¾ problem: zone has turned itself off unexpectedly, a tone sounds and an error code is displayed (typically or alternating with one or two digits in the cooking zone displays). Possible causes: technical fault. What to do: please note down the error letters and num...