NEC 2U SAS JBOD Enclosure Configuration Manual - page 16
CONFIGURATION GUIDE
–
2U SAS JBOD Enclosure
NEC Corporation
Revision 4.0
– July 24, 2015
16
1.5
2U 3.5-inch SAS JBOD Enclosure (2)
Category
Product Name / Description
Part Number
Storage Controller
Required
RAID Controller (2GB, RAID0/1/5/6)
LSI MegaRAID SAS 9380-8e
RAID0/1/5/6/10/50/60, 2GB, Ext. 8, PCIe 3.0 x8, SAS 12Gb/s,
SATA 6Gb/s,
Flash cache protection modules included
N8103-179
Cable
1 to 2 Required
External SATA Cable
2 m, 1 x SFF-8088 to 1 x SFF-8644
K410-322(02)
Enclosure
1 to 2 Required
2U 3.5-inch SAS JBOD Enclosure
12 x 3.5-inch Hot-plug hard drive bays
N8192-102F
Bezel
Front Bezel
For N8192-101F/102F
N8192-302F
Drive
12 slots
available
1TB 7.2K Hot Plug 3.5-inch NL SAS HDD
1 x 1 TB NL SAS HDD, 3.5-inch, 6Gb/s, 7,200 rpm
N8192-505
2TB 7.2K Hot Plug 3.5-inch NL SAS HDD
1 x 2 TB NL SAS HDD,32.5-inch, 6Gb/s, 7,200 rpm
N8192-506
3TB 7.2K Hot Plug 3.5-inch NL SAS HDD
1 x 3 TB NL SAS HDD, 3.5-inch, 6Gb/s, 7,200 rpm
N8192-507
4TB 7.2K Hot Plug 3.5-inch NL SAS HDD
1 x 4 TB, NL SAS HDD, 3.5-inch, 6Gb/s, 7,200 rpm
N8192-509
NOTE:
Storage controllers must be compatible with the server connected.
The drive enclosures connected to one storage controller must be identical.
One drive enclosure can be connected to one port of storage controller.
Four or more disk drives must be installed.
All hard drives within a RAID array should be of the same capacity and rotation speed.
To configure a large-capacity RAID array, it is recommended to configure in RAID 6 or RAID 60 in
order to minimize the risk of becoming multiple hard drives failure during the RAID rebuilding process.
It is recommended to set RAID array configuration drives less than eight in order to minimize the risk
of becoming multiple hard drives failure.
Any of RAID arrays cannot be used as a boot device.