Summary of Dterm Cordless II
Page 1
User’s guide d term cordless ii ®.
Page 2
1 handset controls and functions 1. Ringer on/off slide switch 10. Conference ( conf ) key 2. Message display 11. Transfer ( transfer ) key 3. Hold ( hold ) key 12. Redial ( redial ) or desk/cordless softkey switch key 4. Talk ( talk ) key 13. Channel ( chan ) key 5. Numeric keypad 14. F3 6. F2 15. ...
Page 3: Using Your Phone
2 using your phone before using your telephone you must ensure that: > each base unit is placed at least five feet apart. > the antenna is raised to the vertical position. Making a call 1. Lift the handset and/or press talk . > ‘aquiring link’ blinks in the display while trying to connect to the bas...
Page 4: Programming Mode
3 programming mode 1. Press and hold 4 and # at the same time, then press talk . > ‘f1=lk01’ shows in the display and the f1 led flashes red. 2. Press mute to select the function/line key to program. > (lk01 - lk04 and off-hook ring) 3. Press r/vol key repeatedly to scroll options for each line key....
Page 5: Muting
4 muting 1. Press mute during conversation. > the ‘talk’ icon blinks and the voice through the microphone is muted. 2. Press mute again to cancel the muted condition. (finishing the conversation also cancels the mute condition.) > the ‘talk’ icon stops blinking. Conferencing this feature allows the ...
Page 6: Ringer On/off Slide Switch
5 ringer on/off slide switch when the ringer on/off slide switch (located at side of handset) is turned off, the handset does not ring or vibrate and the ringer ‘off’ icon appears in the display. When the ring ‘off’ icon appears and the terminal is idle for five minutes, the ring ‘off’ icon turns of...
Page 7: Changing Channels
6 programming desk/cordless softkey switching (redial key) this feature switches from desk to cordless mode only. 1. Make sure the base unit is in desk mode. 2. Remove the battery. 3. Press and hold the 4 and # keys on the handset at the same time. 4. Install the battery while pressing and holding t...
Page 8: Traveling Out of Range
7 traveling out of range if function keys ( f1 ~ f4 ) are pressed and no connection is established within five seconds, the telephone times out and returns to standby mode. When using the talk key, the handset sounds an error tone and ‘no service’ displays in the lcd. While talking, if the handset c...
Page 9: Cleaning Battery Contacts
8 cleaning battery contacts to maintain a good charge, it is important to clean all battery contacts on the handset and base about once a month. Use a dry cloth or, if necessary, use a pencil eraser. Do not use any liquids or solvents. Beltclip installation 1. Insert the beltclip into the holes on e...
Page 10: Optional Available Parts
9 optional available parts part description stock number headset 730602 charging unit without ac adapter 730621 spring-type belt clip 730620 ac adapter for charging unit 730619 ac adapter for base unit 730618 leather carry case 730626 replacement battery 730622.
Page 11
10 notes.
Page 12
750228-0 © 2001 nec america, inc. The material contained herein is subject to change without prior notice at the sole discretion of nec america, inc. D term ® is a registered trademark of nec corporation. Document revision 1 for more information contact: nec america, inc. 6555 n state highway 161 ir...