Notice note that when converting this document from its original format to a .Pdf file, some minor font and format changes may occur causing slight variations from the original printed document. When viewing and printing this document, we cannot guarantee that your specific pc or printer will suppor...
User’s guide d term cordless lite ii ® (dth-4r-1).
1 handset controls and functions 1 headset jack 9. Conference (conf) key 2. Lcd message display 10. Transfer(transfer)key 3. Hold (hold) key 11. Channel (ch) key 4. Talk (talk) key 12. Redial(redial)or desk/cordless softkey switch key 5. Numeric keypad 13. F3 6. F2 14. F4 7. F1 15. Ringer/volume (ri...
2 17. Line out 21. Power 18. Line in 22. Desk led 19. Cordless 23. Desk 20. Cordless led 20 19 21 22 23 18 17.
3 using your phone before using your telephone you must ensure that: each base unit is placed at least five feet apart. The antenna is raised to the vertical position. Making a call 1. Lift the handset and/or press talk. ‘aquiring link’ blinks in the display while trying to connect to the base unit....
4 programming mode 1. Press and hold , and # at the same time, then press talk. ‘f1=lk01’ shows in the display and the f1 led flashes red. 2. Press on/off mute to select the function/line key to program. (lk01 - lk04 and off-hook ring) 3. Press ring/vol key repeatedly to scroll options for each line...
5 muting 1. Press on/ off mute during conversation. The ‘talk’ icon blinks and the voice through the microphone is muted. 2. Press on/ off mute again to cancel the muted condition. (finishing the conversation also cancels the mute condition.) the ‘talk’ icon stops blinking. Conferencing this feature...
6 ringer on/off when the d term cordless lite ii ringer is turned off, the handset does not ring or vibrate and the ringer ‘off’ icon appears in the display. When the ring ‘off’ icon appears and the terminal is idle for five minutes, the ring ‘off’ icon turns off to save battery life. When operation...
7 programming desk/cordless softkey switching (redial key) this feature switches from desk to cordless mode only. 1. Make sure the base unit is in desk mode. 2. Remove the handset battery. 3. Press and hold the , and # keys on the handset at the same time. 4. Install the battery while pressing and h...
8 traveling out of range if function keys (f1 ~ f4) are pressed and no connection is established within five seconds, the telephone times out and returns to standby mode. When using the talk key, the handset sounds an error tone and ‘no service’ displays in the lcd. While talking, if the handset can...
9 cleaning battery contacts to maintain a good charge, it is important to clean all battery contacts on the handset and base about once a month. Use a dry cloth or, if necessary, use a pencil eraser. Do not use any liquids or solvents. Beltclip installation 1. Insert the beltclip into the holes on e...
Notes.
Notes.
Notes.
750248-0 *750248-0* place print date here month/year © 2003 nec america, inc. The material contained herein is subject to change without prior notice at the sole discretion of nec america, inc. D term ® is a registered trademark of nec corporation. Document revision 1 for more information contact: n...
