NEC LCD4020-2-AV User Manual - page 29
English-27
English
MONITOR ID
Sets the monitor ID number from 1-26.
1
IR CONTROL
Selects the mode of the monitor for use with the infra-red remote control when using the
NORMAL
RS-232C daisy chain.
NORMAL
The monitor will be controlled normally by wireless remote controller.
PRIMARY
Choose “PRIMARY” for the first monitor within an RS-232C daisy chain.
SECONDARY
Choose “SECONDARY” for all subsequent monitors within an RS-232C daisy chain.
LOCK
Prevents the monitor from being controlled by wireless remote controller. To return to normal
operation, press the “DISPLAY” button on the remote controller for 5 seconds.
TILE MATRIX
Allows one image to be expanded and displayed over multiple screens (up to 25) through a
distribution amplifier.
H MONITORS
Number of monitors arranged horizontally.
1
V MONITORS
Number of monitors arranged vertically.
1
POSITION
Select which section of the tiled image to be displayed on the monitor.
1
TILE COMP
Turns the TILE COMP feature on.
NO
ENABLE
Enables Tile Matrix.
NO
POWER ON DELAY
Adjusts the delay time between being in “standby” mode and entering “power on” mode.
0 Sec.
“POWER ON DELAY” can be set between 0 and 50 seconds.
POWER INDICATOR
Turns ON or OFF the LED located at the front of the monitor.
ON
If “OFF” is selected, LED will not light when the LCD monitor is in active mode.
MULTI DISPLAY RESET
Resets the following settings within the MULTI DISPLAY menu back to factory setting:
-
MONITOR ID, IR CONTROL, TILE MATRIX, POWER ON DELAY.
POWER SAVE
Sets how long the monitor waits to go into power save mode after a lost signal.
ON
All inputs except for TV
Note: When connecting DVI, video card might not stop sending digital data even if image has
disappeared. In this case the monitor does not get to power management mode.
STANDBY MODE
Lowers power consumption.
STANDBY
Note: RS-232C Function is lost when in Eco Standby mode.
HEAT STATUS
Displays status of the COOLING FAN, BRIGHTNESS and TEMPERATURE.
-
FAN CONTROL
Cooling fan reduces the temperature of the display.
AUTO
SCREEN SAVER
Use the SCREEN SAVER function to reduce the risk of Image Persistence.
GAMMA
The display gamma is changed and fixed when “ON” is selected.
OFF
BRIGHTNESS
The brightness is decreased when “ON” is selected.
OFF
MOTION
The screen image is slightly expanded and moves in 4 directions (UP, DOWN, RIGHT, LEFT)
OFF
at user determined intervals.
SIDE BORDER COLOR
Adjusts the color of the side borders when a 4:3 image is displayed.
15
Press + button, the bar will become lighter.
Press - button, the bar will become darker.
AUTO BRIGHTNESS
Adjusts the brightness level according to the input signal.
OFF
DVI, VGA, RGB/HV inputs only
CHANGE SECURITY
Allows the security password to be changed.
-
PASSWORD
The factory preset password is 0000.
SECURITY LOCK
Locks the security password.
OFF
DDC/CI
ENABLE/DISABLE: Turns On or OFF the two way communication and control of the monitor.
ENABLE
DISPLAY PROTECTION
Resets the following settings within the DISPLAY PROTECTION menu back to factory setting:
-
RESET
POWER SAVE, FAN CONTROL, SCREEN SAVER, SIDE BORDER COLOR, AUTO
BRIGHTNESS.
*: The product you purchased may not have this feature.
MULTI DISPLAY
DISPLAY PROTECTION