1 wireless lan unit installation guide model: np02lm nec display solutions, ltd. 2010
2 fcc compliance this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. This equ...
3 industry canada statement this device complies with rss-210 of the industry canada rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of th...
4 table of contents 1. Introduction ...............................................................................................................................5 2. Connecting to a wireless lan ................................................................................................6 3. Te...
5 1. Introduction thank you purchasing the wireless lan unit np02lm series (wireless lan unit). Set the wireless lan unit in the nec projector (described below) for use. Refer to the user’s manual that comes with the projector for installation or removal procedures and for how to set the wireless la...
6 2. Connecting to a wireless lan the wireless lan unit also provides a wireless lan connection. To use a wireless lan connection, you are required to assign an ip address to the projector. Important: • if you use the projector with the usb wireless lan unit in the area where the use of wireless lan...
7 prepare a phillips screw driver beforehand. 1. Press the power button to turn off the projector and set it into standby condition, and disconnect the power cord. 2. Remove the usb (lan) port cover. Loosen the screw securing the port cover. • the screw is not removable. 3. Slowly insert the usb wir...
2.
3 network settings of wireless lan unit.
4.
5 setting up the projector for a wireless lan connection (with the wireless lan unit equipped) [wirless lan] hints on how to set up lan connection to set up the projector for a lan connection:access the http server function to display the web browser (→ page xx) and select [network settings] → [sett...
6 to display the web browser (→ page xx) and select [network settings] → [settings] → [wireless lan] → [profile 1] or [profile 2].Make necessary settings for [settings] and click [save].From the projector menu, select [setup] → [wireless lan] → [profile] → [profile 1] or [profile 2]. To select an ss...
