North Creek Big Kat North D28 User Manual - page 20
Connecting to the Binding Posts
Binding posts fit in the horizontal holes of the rear cover, as follows: on the outside
goes the hex-head, ring and stop. On the inside goes the gold-plated star washer and
one nut. Tighten to prevent spinning. Next comes the gold-plated crossover connector
(described below), followed by a second gold plated nut.
1) Attach the Big as Texas Post
binding posts to the rear covers in the order of Red-
Black-Black-Red.
2) Attach the loudspeaker internal wiring to the binding posts as follow:
White (tweeter +) to Red Post #1.
Blue insulated (tweeter -) to Black Post #1.
Black insulated (woofer -) to Black Post #2.
Coil lead (woofer +) and long red lead to Red Post #2.
3) Make sure the nuts are good and tight, the dab nail polish on the thread of the
binding posts to prevent the nuts from coming loose.
Woofer Inductor Installation
With the cabinet standing up on its Plinth, liberally coat the bottom and corners of the
large woofer inductor with silicone or mastic. Set the inductor on the bottom of the
cabinet such that the bottom and two coated corners are touching the back left corner of
the cabinet (as viewed from the front). Add more adhesive. Let dry overnight.
Back Cover Installation
Spray paint the heads of the 1 5/8 screws jet black. Fusion Satin Black works best.
Adhere gasket tape to the inner back and attach the back cover.