Atv boom kit item #268195 m268195h.1 owner’s manual shown attached to atv spot sprayer #268199 (not included) any questions, comments or problems? Call customer service 1-800-270-0810 0 2 3 8 6 ®.
2 thank you thank you for purchasing the north star atv boom kit. The assembly instructions that follow will help you attach the kit to your existing north star spot sprayer. The numbers in parenthesis throughout the manual refer to the diagram number on the parts explosion and corresponding compone...
3 fasteners-268195 parts any questions, comments or problems? Call customer service 1-800-270-0810
4 pre-assembly step 1: loosen the hose clamp on the existing gun hose. Remove the hose from the pump. Save the hose clamp for step 3. Step 2: slide on one hose clamp onto one end of the supply hose. Push the hose onto the outlet of the pump. Slide another hose clamp onto the supply hose. Push the in...
5 step 4: attach the nozzle arm to the boom mount pivot with (2) 5/16-18 x 3/4” flange bolts, (2) 5/16 flat washers, and (2) 5/16-18 flange nuts. Do not tighten bolts until step 5. Step 5: attach the 3/8” hose barb to the nozzle arm with the nut as shown. Do not tighten until step 6. Apply thread se...
6 step 7: attach the 3/8” boom supply hose to the 3/8” hose barb and attach with the hose clamp. Complete the adjustment of the boom mount pivot by rotating the boom assembly until the upright of the nozzle arm is perpendicular to the ground. Tighten the 5/16-18 flange bolts(the pivot is to accommod...
7 boom kit calibration below are some guidelines to help you calibrate your boom sprayer. This is a very important step in operating your boom sprayer so that you don’t apply too much or too little chemical. 1. Use the suggested application rate (i.E. Gallons per acre, 1000 sq.Ft., or 100 sq.Ft.) 2....
8 parts explosion 268195 rev. H.1 diag. # part # description qty. 1 5213 female garden hose thread swivel nut 2 2 5380 3/8” flat seat hose barb 2 3 5232 rubber washer 2 4 5210 3 way ball valve 1 5 30746 hose clamp 4 6 30290 3/8” boom supply hose 48” 7 5387 3/8” hose barb x 3/4” mght 1 8 30290 3/8” h...
9 this page has intentionally been left blank..
10 manufactured by northern tool + equipment co., 2800 southcross drive west p.O. Box 1499 burnsville, mn 55337-0499 tm.
