North Star Design 192 User Manual - page 5
9
. 96 Led
This led glowing blue while the lock led glows blue means that a 96 KHz sampling
rate has been recognized on any enabled input, e.g. when connecting a DVD audio
(96/24) player.
10
. 192 Led
This led glowing blue while the lock led glows blue means that a 192 KHz sampling
rate has been recognized on I2S input.
11
.
Upsampling led
This led glowing blue while the oversampling function is on.
12
. Upsampling selection
pushbutton
Push to switch from upsampling to direct function.
13
.
Coaxial Input (S/PDIF) 1
Use this input to connect the DAC to the digital output of a source (CD transport,
DAT tape, DVD player), using a 75 Ohm digital cable provided with RCA connectors (not
shipped with the equipment).
14
. Optical Input (TOSLINK) 1
Use this input to connect the DAC to the digital output of a source (CD transport,
DAT tape, DVD player), using a digital fiber optic cable (not shipped with the equipment).
15
.
Coaxial Input (S/PDIF) 2
Use this input to connect the DAC to the digital output of a source (CD transport,
DAT tape, DVD player), using a 75 Ohm digital cable provided with RCA connectors (not
shipped with the equipment).
16
. Balanced Input (AES/EBU) 3
Use this input to connect the DAC to the digital output of a source (CD transport,
DAT tape, DVD player), using a 110 Ohm digital cable provided with XLR connectors (not
shipped with the equipment).
17
. I2S Digital Input 4
Use this input to connect the DAC to the digital I2S output.
18
. Analog Output
Use this output to connect the DAC to the input of a preamplifier or integrated
amplifier using interconnect provided with RCA connectors (not shipped with the
equipment).
19
. Mains Switch
5