North Star Design Incanto Operating Manual - page 7
Front Panel
1 HEADPHONE OUTPUT CONNECTOR
Plug here your headphone. Refer to SETUP section to correctly select the headphone output level.
2 STAND- BY LED INDICATOR
The
Stand- by LED
show the operating mode of your converter:
Glows red
when the DAC is in Stand-by.
Off
the DAC is ready to use.
If the DAC will not turn on, you may want to check the
rear panel AC mains switch
, your AC
connections, or have your dealer inspect the rear panel fuses.
3 VOLUME/SETUP DISPLAY
Three digit display shows the attenuation level in operative mode and the available configurations in
setup mode.
4 HEADPHONE LED INDICATOR
When the led glows blue, indicates the headphone output is active.
5 FREQUENCY/INPU T/SUBSETUP DISPLAY
The three digit display shows the sampling frequency of the track playing in operative mode, or the
available configurations in the setup mode. The recognized frequency in PCM mode are: 44.1kHz,
48kHz, 88,2kHz, 96kHz, 176,4kHz, 192kHz, 352.8kHz, 384kHz. While in DSD mode are recognized
native x64 x128 x256 (352.8kHz, 384kHz and native DSD only on USB).
6 VOLUME/INPUT/SETUP KNOB
In Stand-by – pressing the knob for some seconds the DAC enter in SETUP mode (see the SETUP
section). Pressing newly the knob the DAC will back in stand-by status (see the KNOB CONTROL
section).
In Operative mode – turn left/right the knob to decrease/increase the volume. Pressing the knob the
DAC enter in INPUT MODE. Turn left/right the knob to decrease/increase the input. Pressing again to
exit from INPUT MODE (see the KNOB CONTROL section).
7
REMOTE SENSOR