North Star M157204B Installation, Operation And Maintenance Manual

Summary of M157204B

  • Page 1

    M157204b.1 installation, operation, and maintenance manual pressure washer : c leans dirty surfaces with high pressure water. To the owner: thank you for purchasing a northstar pressure washer. Your machine is designed for long life, dependability, and the top performance you demand! Take time now t...

  • Page 2

    2 table of contents important safety instructions 2 maintenance instructions 10-11 machine component identification 3 moving and handling instructions 12 installation instructions 4-6 long term storage 12 operation instructions 7-8 troubleshooting 13 safety features 9 parts breakdowns 14-15 limited ...

  • Page 3

    3 machine component identification ref # description ref # description 1 pump oil fill 6 engine controls (see engine manual) 2 pump oil drain 7 engine start/stop switch 3 pump inlet (garden hose) 8 engine oil fill 4 pump outlet (pressure hose) 9 engine oil drain 5 pressure adjustment (unloader) 10 h...

  • Page 4

    4 installation instructions i.) unpack your pressure washer is shipped in one box. Separate and identify the components found in the box. Use the assembly instructions in this manual for assembly. Handle gun, lance, and wand holder box fig00951.

  • Page 5

    5 hardware bag.

  • Page 6

    6 ii.) assembly instructions iii.) pump preparation a.) remove red shipping plug from oil fill hole. B.) install vented dipstick into oil fill hole. C.) make sure the oil level is between the marks on the dipstick. Iv.) engine preparation a.) fill engine with oil. (see chart below) b.) fill fuel tan...

  • Page 7

    7 operating instructions read and understand the entire manual before operating the pressure washer. Follow these instructions every time you use the pressure washer. I.) pre-operation a.) position the machine for easy access to all controls. B.) position the machine on a solid surface, with less th...

  • Page 8

    8 vii.) attach nozzle color of nozzle: spray angle used for: red 0 highest impact yellow 15 tough stains/ stripping green 25 general white 40 light cleaning black 65 applying chemicals your pressure washer is equipped with five nozzles. To install a nozzle simply pull back the collar and push the no...

  • Page 9

    9 x.) cleaning warning: wear eye, ear, hand, foot and skin protection at all times while operating this pressure washer. Danger: do not point the spray wand at yourself or at any person. Bodily injury may result from water under high pressure. Caution: be careful on painted or delicate surfaces, the...

  • Page 10

    10 maintenance instructions *refer to the honda engine owner’s manual for engine maintenance instructions maintenance mode before performing any maintenance on the pressure washer, it must be placed in maintenance mode. A.) turn off engine b.) turn off water supply c.) bleed water from system d.) sh...

  • Page 11

    11 belt tension some general rules of belt tension are: 1.) ideal tension is the lowest tension without belt slippage. 2.) over tightening decreases belt and bearing life. 3.) keep belts clean and free of foreign material that may cause slippage. 4.) tighten belts when slipping. 5.) never apply belt...

  • Page 12

    12 moving and handling instructions maneuvering your pressure washer 1.) pull the handle up with both hands. 2.) pull the pressure washer behind you as you walk. Lifting your pressure washer 1.) to reduce risk of injury, it is recommended that two adults lift the pressure washer. 2.) only lift the p...

  • Page 13

    13 troubleshooting engine will not start causes solutions low oil shutdown fill engine with the adequate amount of oil cold engine choke engine to start no fuel add gas to engine - make sure fuel shutoff valve is open pressure build-up from initial use trigger spray gun to relieve pressure engine no...

  • Page 14: M157204B.1

    14 item pn description qty item pn description qty 1 221222 chemical strainer 1 24 778295 turf tire 2 2 777165 ¼” braided chemical hose 3ft 25 601091 honda gx390 1 4 36003 gun holder 1 26 2005 pulley 2bk36h 1 5 38532 nozzle 5 pack 3.5 1 28 777115 bx42 grip notch belt 2 6 777111 grommet 5 31 35997 pu...

  • Page 15

    15.

  • Page 16

    16 this page has intentionally been left blank..

  • Page 17: Limited Warranty

    17 limited warranty dear valued customer: the northstar product you just purchased is built with the finest material and craftsmanship. Use this product properly and enjoy the benefits from its high performance. By purchasing a northstar product, you show a desire for quality and durability. Like al...

  • Page 18

    18 manufactured by northern tool + equipment co., 2800 southcross drive west p.O. Box 1499 burnsville, mn 55337-0499 ®.