North Star NSC30UD1 Installation Operation & Maintenance - page 19
19
Ultra II
DEMAND TIMER FEATURES, SETTINGS, AND SERVICE, continued
RECHARGE NOW
Press and
hold
in the RECHARGE button
until
RE-
CHARGE NOW
starts to flash in the time display
area. The softener begins an immediate regenera-
tion, and when over in about two hours, you will have
a new supply of soft water. Once started, you cannot
cancel this regeneration.
RECHARGE TONIGHT
Touch
(do not hold)
the RECHARGE button, and
RECHARGE TONIGHT
flashes in the time display
area. A regeneration will occur at the next preset re-
generation start time. If you decide to cancel this re-
generation,
before it has started,
touch the same
button once more.
VACATION NOTE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The Ultra II Demand water softener regenerates only while water is used and softening capacity must be re-
stored. For this reason, the softener will not regenerate when you are away from home for extended periods.
feature:
PROGRAM MEMORY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If electrical power to the softener is interrupted, the
time display is blank, but the timer keeps correct
time for about 24 hours. When power is restored,
you have to reset the present time
only if
the display
is flashing.
All
other settings are maintained and
never require resetting unless a change is desired.
If the time
is
flashing after a long power outage, the
softener continues to work as it should to provide
you with soft water. However, regenerations may oc-
cur at the wrong time of day until you reset the timer
to the correct time of day, page 11.
setting:
REGENERATION (STARTING) TIME, MAXIMUM DAYS BETWEEN REGENERATIONS,
EFFICIENCY MODE, HEAVY DUTY BACKWASH AND 97% FEATURE . . . . . . . . . . . . . . . . . . . . . .
NOTE: Each of these settings has a factory set default value. The defaults are: Regeneration start time --
2:00AM;
Maximum days between regenerations --
0 (display shows dY --)
; Efficiency Mode --
OFF
; 97% Fea-
ture --
OFF
; Heavy duty backwash --
OFF
. The defaults suit most installations. However, depending on water
supply quality, household peak water use hours, etc., adjustment is available to meet specific needs. To make
a change, read and do the following.
continued