E l e c t r i c r e b a r c u t t e r owner’s manual warning: read carefully and understand rules for safe operation and instructions before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item # 999320
Page of 11 2 for technical questions and replacement parts, please call 1-800-222-5381. Thank you very much for choosing a northern tool + equipment co., inc. Product! For future reference, please complete the owner’s record below: model: _______________ purchase date: _______________ save the recei...
Page of 11 3 warning: the warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must b...
Page of 11 4 or medication. A moment of inattention while operating power tools may result in serious personal injury. Dress properly. Do not wear loose clothing of jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts....
Page of 11 5 results in personal injury. Keep handle dry, clean and free from oil and/or grease. Keep housing and piston free of dirt and iron filings. Check that no screws or bolts are loose or missing. Following instruction for maintenance. Inspect switch, cord, plug and any extension cable at reg...
Page of 11 6 fig. 1 cutting 1. Be especially careful when cutting off short lengths (12 inches or less) as the but end tends to fly out. Caution: flying ends are a hazard to all personnel in the vicinity. Erect safety screens. 2. Do not cover air vents. If the events are covered, motor will overheat...
Page of 11 7 2. Wipe or brush away all dirt and metal filings. Pay particular attention to the lower half of the piston, where dirt is more easily accumulated. Hydraulic oil level check as the cutters are hydraulically operated, the hydraulic oil level must be checked at frequent intervals, preferab...
Page of 11 8 carbon brushes inspect the two carbon brushes at least once every two months. (nominal brush life is 200 hours). Worn brushes will result in loss of power, cause the motor to run hot and irreparably damage the armature’s commutator. 1. Disconnect unit from power supply. 2. Unscrew both ...
Page of 11 9 diagram & parts list.
Page of 11 10 item specification item specification 1 cylinder 39 spring washer m5 2 ball bearing 40 cap bolt m5*18 3 piston 41 cutter block 4 return spring 42 spring washer m5 5 valve 43 cap bolt m5*5 6 spring valve 44 locking spring 7 spring guide 45 stopper bolt m10*40 8 pump seal plug 46 side ha...
Page of 11 11 warning some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the state of california to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, ...
