2800 southcross drive west, po box 1219 burnsville, mn 55337, usa electric hoist item# 14226 item# 14230 item# 142260 item# 142262 assembly and operating instructions read carefully and understand all assembly and operation instructions before operating. Failure to follow the safety rules and other ...
Product specifications model load capacity lifting height lifting speed cable length cable diam eter res ister cable duty circle voltage motor performance hgs220/440lb hgs550/1100lb hgs750/1500lb hgs1000/2000lb standard version with pulley hook 220lb 36ft 33ft/m in 39ft ≥1540lb s3 20% -10m in 110v/6...
Electrical safety 4. Grounded tools must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a qualified electrician if you are in doubt as to w...
12. Avoid accidental starting. Be sure the power switch is off before plugging in. Carrying power tools with your finger on the power switch, or plugging in power tools with the power switch on, invites accidents. 13. Remove adjusting keys or wrenches before turning the power tool on. A wrench or a ...
22. Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool. Service 23. Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualifi...
Additional specific safety rules 10. Do not exceed the maximum lift capacity. The application, size and type of load, the attachments to be used and the period of use must be taken into account. 11. Do not stand under hoisted loads. 12. Do not operated the hoist in wet conditions. Do not allow the h...
Warning! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker. Grounding warning! Improperly connecting the grounding wire can result in the r...
Double insulated tools: tools with two prong plugs 4. Tools marked “double insulated” do not require grounding. They have a special double insulation system which satisfies osha requirements and complies with the applicable standards of underwriters laboratories, inc., the canadian standard associat...
6. If you are using an extension cord outdoors, make sure it is marked with the suffix “w-a” (“w” in canada) to indicate it is acceptable for outdoor use. 7. Make sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired ...
Figure 2 assembly and operating instructions hoist set-up warning! Unplug the hoist before set-up. 1. This hoist is designed to be attached to a beam or steel pipe and bed securely held in place by both of the hangers (#23). See figure 2. Note: the beam or steel pipe must be capable of carrying seve...
Operation (continued) using the hoist refer to figure warning! As illustrated in figure 2, the cable (#56) must flow through the cable guard (#29), and the stopper (#31) must be securely attached to the end of the cable (#56). 1. Plug in the unit and press the switch (#43) toward the “down” position...
Parts list part no. Description part no. Description 1 cover fan 30 screw 2 impeller 31 stopper 3 shield 32 clamp 4 stator 33 connector 5 screw 34 hook 6 bearing 35 bearing 7 basket 36 pinion 8 hub 37 key 9 hub gasket 38 connector 10 spring 39 switch/cable 11 shaft 40 spring 12 bearing 41 screw 13 f...
Page 13.
