Northern Industrial Tools 143384 Owner's Manual - page 4

TOOL USE AND CARE

•   Do not force the power tool. Use the correct power tool for your application. The 

correct power tool will do the job better and safer at the rate for which it was designed. 

•   Do not use the power tool if the switch does not turn it on and off. Any power tool

that cannot be controlled with the switch is dangerous and must be repaired by an 

authorized service representative.

•   Disconnect the power from tool and place the switch in the locked or off position

before making any adjustments, changing accessories, or storing power tools. Make

sure blade has stopped. Such preventive safety measures reduce the risk of starting the

power tool accidentally.

•   Secure work with clamps or a vise instead of your hand to hold work when practical.

This safety precaution allows for proper tool operation using both hands.

•   Store idle power tools out of the reach of children and do not allow persons 

unfamiliar with the power tool or these instructions to operate the power tool. Power

tools are dangerous in the hands of untrained users.

•   Maintain power tools. Check for misalignment or binding of moving parts, breakage

of parts and any other condition that may affect the power tools operation. If 

damaged, have the power tool repaired before use. Many accidents are caused by

poorly maintained power tools.

•   Use only accessories that are recommended by the manufacturer for your model.

Accessories that may be suitable for one tool may create a risk of injury when used on

another tool.

•   Keep guards in place and in working order.

•   Never leave tool running unattended.

•   Before drilling into walls, ceilings etc, ensure there are no concealed power cables or

pipes in the cavity.

•   Always use the side handle; this gives you greater control if the accessory should

become jammed.

•   Keep the cord clear of the accessory being used. Do not wrap the cord around your

arm or wrist.

•   Get a good grip. Hold the tool by the insulated gripping surfaces when performing an

operation where the accessory may contact hidden wiring or its own cord.

•   Use thick cushioned gloves and limit the exposure time by taking frequent breaks.

Vibration caused by the hammer action may be harmful to your hands and arms.

•   When removing an accessory from the tool, avoid contact with skin and use proper 

protective gloves when grasping the bit or accessory. Accessories may be hot after 

prolonged use.

•   Always wear eye protection and a dust mask, especially for dusty applications and

when drilling / chiseling overhead. Sanding particles can be absorbed by your eyes and

inhaled easily and may cause health complications.

WARNING! The use of any accessory or attachment, or performance of any operation

with this tool other than those recommended in this instruction manual may present a risk of 

personal injury.

3