5-speed bench drill press with laser owner's manual item # 155301 warning: read carefully and understand all instructions before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury..
1 thank you very much for choosing a northern tool + equipment co., inc. Product! For future reference, please complete the owner's record below: model: _______________ purchase date: _______________ save the receipt, warranty and these instructions. It is important that you read the entire manual t...
2 • be aware of all power lines, electrical circuits, water pipes and other mechanical hazards in your work area, particularly those hazards below the work surface hidden from the operator's view that may be unintentionally contacted and may cause personal harm or property damage. • be alert of your...
3 • avoid accidental starting. Do not carry the power tool with your finger on the switch. Ensure the switch is in the off position before plugging tool into power outlet. In the event of a power failure, while a tool is being used, turn the switch off to prevent surprise starting when power is rest...
4 • clamp workpiece or brace against the left side of the column to prevent rotation. If it is too short or the table is tilted, clamp solidiy to the table and use the fence provided. • if the workpiece overhangs the table such that it will fall or tip if not held, clamp it to the table. Provide aux...
5 check the parts againts the above list and refer to the diagrams. Should there be any deficiencies or damage, you should contact northern tool + equipment. Getting to know your drill press assembly 1. Position base on workbench. 2. Remove protective sleeve from column tube and discard. Place colum...
6 6. Find elevation worm gear shaft in the loose parts bag. Insert the elevation shaft into the table support and extend the shaft through the opening as far as possible. The crank is to be installed on the elevation worm gear shaft, the set screw is to be aligned with the flat portion of the shaft....
7 laser attachment introduction safety rules for laser lights the laser light/laser radiation used in the lightsabre system is class 2 with maximum 1mw and 640 - 660nm wavelengths. These lasers do not normally present an optical hazard, although staring at the beam may cause flash blindness. Warning...
Caution! Remove the laser light batteries when the tool is to be stored without use for a few days or more. If left in position, the batteries might leak and damage the laser light assembly. Damage due to leaking batteries is not covered under warranty. Operation drill “on-off” switch this feature i...
9 warranty one-year limited warranty for warranty questions, call 1-800-222-5381 diagram & parts list.
10
Northern tool + equipment co., 2800 southcross drive west p.O. Box 1499 burnsville, mn 55337-0499 made in china warning some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the state of california to cause cancer, birth defects...
