6in. Cutoff saw owner’s manual warning: read carefully and understand all assembly and operation instructions before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item# 338070
Page of 9 2 thank you very much for choosing a northern industrial product! For future reference, please complete the owner's record below: model: _______________ purchase date: _______________ save the receipt, warranty and these instructions. It is important that you read the entire manual to beco...
Page of 9 3 important safety considerations make sure the cutoff wheel is securely mounted as described in the assembly instructions, before connecting the tool to a power supply. Do not tighten wheel excessively, since this can cause cracks. Check wheel for fissures and cracks, and test for normal ...
Page of 9 4 cutoff wheel installation warning! Use only reinforced, 6in. Cutoff wheels, rated for 10,000 rpm or higher. 1. Disconnect saw from the power source. 2. Inspect the replacement wheel for defects such as cracks, chipping, and correct speed rating. If defects are found or the speed rating i...
Page of 9 5 1. Using the supplied allen wrench, loosen screws (26) behind the vise fence (23). 2. Rotate the vise fence until the desired angle of cut is aligned with the indicator arrow in th saw base (14). 3. Check the angle of the vise fence to the cutoff wheel using a protractor, bevel square, o...
Page of 9 6 1. Firmly secure the material to be cut using the saw’s vise. 2. Start the saw by pressing safety on/off button and pulling the trigger. Note: allow the cutoff wheel to come up to full speed before contacting wheel to material. 3. Slowly push down on the saw arm handle until the cutoff w...
Page of 9 7 this cutoff saw has a quick brush change system. 1. Use slotted screwdriver to remove the the brush caps. 2. Take out the worn brush and insert the new one. Diagram & parts list.
Page of 9 8 for replacement parts and technical questions, please call 1-800-222-5381..
Page of 9 9 warning some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the state of california to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, • ...
