Northern Tool 102180 Owner's Manual - page 5
Page: 5 of 8
OPERATION
Set Up
Fig. 1
1. You will need to prepare a 1/4" air connector (sold separately) to connect to the Air Inlet.
First, wrap the 1/4" air connector (not included) with pipe thread seal tape before
connecting to an Air Source Hose (not included).
2. Attach air hose to the Air Inlet on the Angle Sander. Note: If you are not using an automatic
oiler system, before operation, add a few drops of Pneumatic Air sander Oil to the airline
connection. Add a few drops more after each hour of continual use.
3. Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air
pressure of 90 PSI.
4. Check the air connection for leaks.
5. Turn off the compressor and disconnect the air source hose in preparation to add discs to
the Angle Sander.
6. Assembling the pad with the pin.
STEP 1 STEP 2 STEP 3 STEP 4
MAINTENANCE
WARNING:
Make sure the air sander is disconnected from its power source before
attempting any maintenance, cleaning, or inspection.
•
Maintain your air sander.
It is recommended that the general condition of any air sander be
examined before it is used. Keep your air sander in good repair by adopting a program of
conscientious repair and maintenance in accordance with the recommended procedures found
in this manual. If any abnormal vibrations or noise occurs, turn the air sander off immediately
and have the problem corrected before further use. Have necessary repairs made by qualified
service personnel.