Northern Tool QCPS?28000 Owner's Manual Addendum - Warning
Addendum for QCPS‐28000 Pellet Stove Owner’s Manual
OPERATING INSTRUCTIONS
5. The unit has entered the start‐up period and pellet is now feeding under the pre‐set rate.
6. After 5 minutes, the pellet is then burning normally and you can select the HEAT LEVEL and BLOWER
air flow as below:
ADJUST HEAT RATE – Press UP and DOWN button at left side of control panel to select pellet feed
rate to adjust the heat ouput.
The LED display at left shall show 1 – LOW, 2 – MEDIUM, 3 – HIGH.
REFILL
1. Press O/I switch once to turn the unit OFF.
2. The pellet will stop feeding but the unit will run for a few minutes.
3. After the unit is cooled, open hopper lid and fill pellets into hopper.
4. Restart the unit by pressing O/I once.
SHUT DOWN PROCEDURE
Press O/I once to turn the unit OFF. The blower and exhaust fan will run for a few minutes until the
pellets in firebox are completely burnt. The unit can only be restarted when the internal temperature
fallen into preset level.
WARNING
• Keep hopper lid and front door closed at all times. Do not overfill hopper.