NorthQ NQ-500 Installation Manual - page 13
of
16
13
Danfoss Living Connect Installation
Click on
Finish
Check if
Danfoss Living Connect is found
To create a room, click
here
Assign the thermostat to a
room
19
16
17
18
WELL DONE!
You have finished installing your
Danfoss Living Connect. Your
HomeManager account should now be receiving data from it.
Remember that you can see the set point change within 5 min
or after you press any button on the
Danfoss Living Connect.
Please note that you can’t install more than
16 thermostats
and create more than
9 rooms.
If
not, check FAQ section on northq.com
As one or more thermostats will heat up one room you have to
assign each thermostat to the room you want to control.
1