Northstar™ 190 bath/spa tv installation instructions.
Test the lcd-tv prior to sealing the unit, turn on the lcd tv and make sure it is operating properly. Seal the lcd-tv when you are sure that the unit is installed and operating correctly, turn the tv off and apply a clear non- corrosive* silicone sealant to the joint between the edges of the stainle...
If using the ceiling bose™ freespace®ceiling mount options: select rough-in pan location on the ceiling. See below for installation steps. If using the bose™ wall mount options: mark the location of the bracket plate on the wall. See below for installation steps. The following steps explain how to i...
4. Insert the bose™ speaker through circular cut out. 5. Connect the rca cable to the speaker terminal. The live wire (black) is connected to the positive terminal and the neutral wire (white) is wired to the negative terminal. Connect the rca cable to the speaker source on the 4 port wall plate. 6....
7. Secure the speaker by tightening all screws. The screws will pull the speaker lock-down and secure the speaker in place. Conduit without plenum cover 1. Install the bose™ 8/32 junction box onto the metal pan. Connect the conduit with rca cable inside, to 4-port wall plate. 2. Align the metal pan ...
6. Connect the wire from the junction box cable (covered with conduit) to the speaker terminal. The live wire (black) is connected to the positive terminal and the neutral wire (white) is wired to the negative terminal. Screw the security bracket onto the back of the speaker. 7. Secure the speaker b...
7. Secure the speaker by tightening all screws. The screws will pull the speaker lock-down and secure the speaker in place. Inserting speaker cover 1. The speaker cover can be installed straight to the speaker if the sheet rock ceiling/wall does not need any additional painting. 2. Use paint protect...
