NorthStar 15781520 Owner's Manual - page 12
12
Step 2. Assembly
Note: Remove contents from packaging to begin
assembly.
Handle Assembly
1.) Attach handle to base using:
a. (2) Carriage Bolts (82233)
b. (2) T-Handle Knobs (38578)
2.) Mount hose hook onto the handle using:
a. (1) Hose Hook (788596)
b. (2) Nyloc Nut (777495)
3.) Insert the Nozzles into the Nozzle Holder
Spray Gun Assembly
4.) Attach the Lance to Spray Gun
a.) Tighten spin-on coupler hand tight.
Note: The o-rings make the seal so there is no need to
tighten with a wrench.
Step 3. Select Suitable Location
Moving and Handling
Moving your pressure washer around
Use the handles to manually move the pressure
washer.
Push the pressure washer in front of you has you
walk.
To turn, push down slightly on the handles and
pivot the pressure washer on its wheels.
Elevating or lowering your pressure washer
To reduce risk of injury, it is recommended that
two adults lift the pressure washer.
Only lift the pressure washer by the bumper and
handle. Do not use the pump or engine as a lifting
point.
WARNING: Lifting hazard
The pressures washer is heavy. It can crush and cause
serious injury if it rolls out of control or tips over. Follow
the instructions below for safely moving the pressure
washer.
Outdoor Use Only
Select a suitable outdoor location:
1. Never run the pressure washer in an enclosed
or partially enclosed location such as a building,
garage, barn, shed, or house. These spaces
can trap poisonous gases. Running a fan or
opening windows will not provide adequate
ventilation to prevent dangerous CO build-up.
2. Only use the pressure washer outdoors and
ONLY run pressure washer OUTDOORS and at
least 20 feet from the home, away from
windows, vents and air intakes, to allow proper
ventilation. If you start to feel sick, dizzy, or
weak while using the pressure washer, shut off
the engine and get to fresh air RIGHT AWAY.
3. Place the pressure washer so that the exhaust
fumes will not be directed towards people or
building air intakes.
4. Do not locate and use the pressure washer in
the presence of flammable vapors, dust, gases,
or other potentially combustible materials.
5. Ensure that working, battery-operated or battery
back-up carbon monoxide alarms are used in
any dwelling/structure that is in close proximity
to the running pressure washer.
6. Note that this pressure washer is NOT designed
or approved for use in vehicles or marine
Handle
Nozzles
Nozzles Holder
Hose Hook
Carriage Bolts
T-Handle Knob
Nyloc Nut
Lance
Spin-On Coupler
Base