1. DL manuals
  2. NorthStar
  3. Air Compressor
  4. M36029L
  5. Installation, Operation And Maintenance Manual

NorthStar M36029L Installation, Operation And Maintenance Manual

Manual is about: NorthStar Gasoline Stationary Air Compressor

Summary of M36029L

  • Page 1

    Gasoline stationary air compressor installation, operation and maintenance manual to the owner: thank you for purchasing a northstar air compressor. Your machine is designed for long life, dependability, and the top performance you demand! Please take time now to read through this manual so you bett...

  • Page 2

    2 table of contents important safety instructions 2 maintenance 6 receipt and inspection 2 kits & service parts 6 machine component identification 3 exploded view / component list 7-8 assembly 4 pneumatic schematic diagrams 9 operation 5 troubleshooting 10 limited warranty 11 safety definitions dang...

  • Page 3

    3 machine component identification 1.) engine control - location of choke, engine speed and fuel valve. 2.) engine - engine is not shipped with oil. Refer to engine owners’ manual for proper viscosity and capacity of oil for your engine. 3.) on/off/start switch - make sure switch is at “on” position...

  • Page 4

    4 assembly step 1. Remove compressor air filter from pallet. Step 3. Bolt compressor air filter to compressor inlet. Step 2. Remove tape from compressor inlet. Step 4. Mounting dimensions 01046 air filter bolt (in manual bag) remove tape remove lag bolts and washers and discard.

  • Page 5

    5 operation initial start-up 1.Pump is shipped with oil. Remove the oil cap and check pump oil level. Add sae 30 non-detergent pump oil (northstar part #35605), if necessary. Hand tighten breather cap. 2. Turn pressure relief knob to engine start position. 3. The engine is shipped without oil. Refer...

  • Page 6

    6 00882 maintenance warning! Disconnect spark plug wire from spark plug and release air pressure from system before performing maintenance. Note: all compressed air systems contain maintenance parts (e.G. Lubricating oil, filters, separators), which are periodically replaced. These used parts may be...

  • Page 7: Exploded View

    7 exploded view ref description part # qty 1 pump, b6000 779103 1 2 guard bracket 35657 1 3 warning decal 34782 1 4 belt guard 37639 1 5 grommet 32871 2 6 belt guard cover 37642 1 7 air tube connector elbow 779227 1 8 ¼” plastic tube, 1200 psi 34746 4’ 9 unloader valve 36022 1 10 ¼” npt street tee 7...

  • Page 8

    8 779103 pump assembly item description part # qty 1 pump head ab6061401 1 2 head bolt (m10 x 55mm shcs) ab9101754 6 3 air filter 35409 1 4 air filter assy. 35404 1 5 intake/after cooler gasket ab5070200 1 6 intake elbow ab9083227 1 7 intake/after cooler bolt (m10 x 20 shcs) ab9101264 4 8 safety val...

  • Page 9

    9 pneumatic schematic diagram safety relief valve pump idle down unloader safety relief valve 30 gallon tank.

  • Page 10

    10 troubleshooting this section provides a list of the more frequently encountered compressor malfunctions, their causes and corrective actions. Some corrective actions can be performed by the operator or maintenance personnel, and others may require assistance of a qualified electrician or service ...

  • Page 11: Limited Warranty

    11 limited warranty dear valued customer: the northstar product you just purchased is built with the finest material and craftsmanship. Use this product properly and enjoy the benefits from its high performance. By purchasing a northstar product, you show a desire for quality and durability. Like al...

  • Page 12

    12 manufactured by northern tool + equipment co., 2800 southcross drive west p.O. Box 1499 burnsville, mn 55337-0499 ®.