Northwest 80-2000A-36 Installation And Operating Instructions Manual

Summary of 80-2000A-36

  • Page 1

    Electric fireplace installation and operating instructions model:80-2000a-36,80-2000a-42,80-2000a-54 important instructions when using electrical heaters, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read al...

  • Page 2

    3. Always unplug heater when not in use. 4. Do not operate any heater with a damaged cord or plug or after heater malfunctions, has been dropped or damaged in any way. 5. Do not use outdoors. 6. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locat...

  • Page 3

    Outlet. Check to see the unit turns on and produces function. 2. This heater is for use on 120 volts. The cord has a plug as shown at a in below figure. An adapter as shown at c is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending fr...

  • Page 4

    Product dimensions unit:mm 80-2000a-36 80-2000a-42 80-2000a-54 before assembly before you assemble your fireplace, you should put the crystals on the ember. Please following below : 1) put the fireplace on flat floor with the front glass panel on top position. 2) use screwdriver(not supplied) to loo...

  • Page 5

    Installation 1.This heater is for wall mounting only. Do not attempt to use it free standing. 2.Referring to fig. 3 below select a suitable position in which to mount the heater horizontally – use a spirit level to achieve this. 3.Check the wall to ensure there is no wiring, pipe wires etc in the ar...

  • Page 6

    Operation remove all packaging before use. Control panel (see also ‘operating instructions’ below) as shown in the photo below you will see the control panel in the right side of the heater. Fig 6 1 power switch 2. Heat control button 3. Flame control button 4. Heater led 5. Power led operating by m...

  • Page 7

    Operating by remote control fig 6 1. Plug in your electric fireplace. Important! The main on/off power switch on the fireplace must be in the on position. 2. When operating the heater with the remote control, it must be pointed at the logset inside the electric stove and the red light must blink eac...

  • Page 8

    High heater work with 1500w “heater” led for red low heater work with 750w “heater” led for blue temp “heater” led for purple adjusting to auto control by room temperature , the heater turns on and work with 1500w when roomemperature is below 22°c, the heater turns on and work with 750w when roomemp...