Summary of CM 351
Page 1
Cm 351 operating intructions.
Page 2
2.
Page 3
3 the undersigned manufacturer: saint - gobain abrasives s.A. 190, bd. J. F. Kennedy l-4930 bascharage declares that the following new products here below: masonry saws (code) • cm 351 2.2kw-1-230v (70184630312) • cm 351 2.0kw-1-115v (70184630321) is in conformity with the following directives: • "m...
Page 4
4.
Page 5
5 cm 351 operating instructions table of contents 1 basic safety instructions 6 1.1 symbols 6 1.2 machine plate 6 1.3 safety instructions for particular operating phases 6 2 machines description 7 2.1 short description 7 2.2 purpose of use 7 2.3 layout 7 2.4 technical data 8 2.5 vibration emission d...
Page 6
6 1 basic safety instructions the cm 41 is exclusively designed for the cutting of construction products, with norton diamond blades, mainly on construction sites. Uses other than the manufacturer's instructions shall be considered as contravening the regulations. The manufacturer shall not be held ...
Page 7
7 2 machines description any modification, which could lead to a change in the original characteristics of the machine, may be done only by saint-gobain abrasives who shall confirm that the machine is still in conformity with the safety regulations. 2.1 short description the cm 351 masonry saw is de...
Page 8
8 conveyor cart (5) steel welded construction with a stop material. The guide system of the conveyor cart permits precise cuts. The guide-a-cut and the large surface of the conveyor cart provide precise positioning of the material. Water cooling system (6) the coolant system comprises: • a powerful,...
Page 9
9 3 assembly and commissioning the machine is delivered fully equipped and ready to use. Before using the machine the first time, please follow the following instructions. 3.1 feet assembly the machine is delivered with the feet dismounted. • mount the feet and tighten them with the locking screws. ...
Page 10
10 4.3 storing of the machine if the machine is not going to be used for a long period, please take the following measures: • completely clean the machine. • empty the water cooling system. • take the water pump out of the slurry and clean it thoroughly. The storage site must be clean, dry and at a ...
Page 11
11 5.2.2 multiple step cutting multiple step cutting consists of moving the conveyor cart with the material to be cut back and forward under the rotating blade as shown. • place the material on the conveyor cart and hold it firmly against the stop (and where appropriate against the guide-a-cut) keep...
Page 12
12 6 maintenance and service to ensure a long-term quality from the cutting and a safe functioning of the machine without any problem, please follow the maintenance plan below: b e g in o f th e w o rk d u ri n g c h a n g in g t h e t o o l e n d o f th e w o rk e v e ry w e e k a ft e r a b re a k...
Page 13
13 7.3 circuit diagram.
Page 14
14 7.4 customer service when ordering spare parts, please mention: • the serial number (7 digits) • the code of the part • the exact denomination • the number of parts required • the delivery address please indicate clearly the means of transportation required such as "express" or "by air". Without ...
Page 15
15.
Page 16
16 saint-gobain abrasives 190, bd. J. F. Kennedy l-4930 bascharage luxembourg tel.: ++352 50401-1 fax: ++352 501633 e-mail: sales.Nlx@saint-gobain.Com www.Construction.Norton.Eu 12.05.10