Nortrac BE-SBS72G Operator's Manual - Danger
SAFETY PRECAUTIONS
1.Be sure all exposed moving parts such as shafts and
adapters are properly guarded and that all coupling
devices are securely attached before applying power. Do
not use unless all shields are in place.
2.Do not wear loose fitting clothing in the vicinity of any
moving parts.
3.Do not exceed recommended ground speed,
recommended PTO speed, or recommended horsepower
for the unit which you are using.
4.Keep all persons, pets, and livestock away from unit
when in use.
5.Do not turn discharge chute towards persons, pets,
livestock, or buildings when blower is in operation.
6.Before working on, servicing, or making adjustments to
equipment, disengage power, lower unit to ground
level, shut off engine, make sure all moving parts have
stopped and all pressure in the hydraulic system in
relieved.
7.Do not attempt to remove any obstruction from
discharge chute until PTO is disengaged and engine is
shut off.
8.Do not stand on auger to service any part of blower, as
auger may turn causing either, a serious fall; or, the
blower fan to rotate, presenting a danger to fingers,
hands, or arms in the chute assembly or blower housing.
9.Keep hands and arms away from cables and turner bar
of hydraulic hood turner until engine is shut off.
10.Always look to the rear before backing up.
11.Be aware of the presence of people and objects that
may be obscured from vision by blowing or drifted
snow. Be certain that no children have tunnelled into
snowbanks which are to be removed. Never let children
slide down snowbanks in the vicinity of an operating
blower.
Colour: Red
Location: Blower Side
Stones or other objects may
be thrown great distances by
the auger, especially at
higher RPMs. Do not stand
in front of the blower when
it is in operation.
Any debris or stones which
are swept into the fan can be
thrown great distances. Do
not allow any bystanders to
stand in the path of the
discharge chute.
Shields are supplied for your protection. Do not remove shields and do
not operate the machine unless all shields are in place.
Do not service, adjust, or repair, until the PTO has been disengaged, the
motor shut off, the unit lowered to the ground, and all parts have stopped
moving. Any moving part has the possibility of entangling the operator or
his clothing, and causing serious injury, dismemberment, or death.
Colour: Red
Location: PTO Shaft
Never
go
near
any
moving
parts.
Because
tractor
PTOs
may
be
accidentally
engaged,
never
attempt
to
lubricate,
repair
or
couple
PTO
unless
tractor
engine
is
shut
off.
Do
not
remove
shields.
Be
sure
that
PTO
shield
turns
freely
and
independently
of
the
driveline.
Do
not
operate
unless
all
shields
are
in
place.
Be
sure
that
PTO
shaft
is
attached
securely
at
both
ends
before
operating.
Colour: Yellow
Location: Blower Back
Do not service, adjust or
repair any equipment
attached to the three-point
hitch hydraulics, without
lowering the unit to the
ground
.
If work must be
performed underneath the
unit, block the unit in a
raised position
.
Colour: Orange
Location: Blower Back
Do not attempt any servicing
of the blower while the
tractor engine is running
.
If the tractor PTO is
accidentally engaged the
serviceman could become
entangled in moving parts
and be seriously injured or
killed
.
Be certain
.
Be safe
.
Shut off the engine
.
Colour: Yellow
Location: Blower Back
Every
effort
is
made
to
ensure
that
a
well
constructed
high
quality
product
leaves
the
manufacturer
.
Again
the
dealer
inspects
and
services
each
unit
before
it
leaves
his
lot
.
To
keep
your
blower
in
good
operating
condition,
please
inspect
and
retighten
as
necessary
any
loose
nuts
or
studs
after
a
half
hour
break
in
period
.
Thereafter
periodic
checks
will
ensure
that
your
blower
remains
in
top
working
condition
.
DANGER
To Prevent Serious Injury Or Death:
Keep hands,feet and clothing away
from auger intake.
DANGER
Shut off engine before
servicing machine.
Éteindre le moteur avant
de faire I’entretien.
CAUTION
Lower or block elevated components before
servicing or when leaving the machine.
Elevated components can fail and cause
serious injury.
Abaissez ou bloquez les éléments surélevés
avant de faire I’entretien lorsque vous vous
éloignez de la machine.Les éléments
surélevés peuvent tomber et causer des
blessures sérieuses.
CAUTION
All nuts and bolts must be
retightened regularly
.
Consult your owners manual.
Tous les écrous et les boulons
doivent être resserrés à
intervalles réguliers.Consultez
le manuel de I’usager.
1
AVOID BODILY INJURY
PRÉVENTION CONTRE
LES ACCIDENTS
1. OBJECTS MAY BE THROWN GREAT
DISTANCES BY AUGER.
LES OBJETS PEUVENT ÊTRE PROJETER À
GRANDE DISTANCE DE LA VIS HÉLICOЇVALE.
2. STAY CLEAR AND WATCH OUT FOR
BYSTANDERS. KEEP ALL SHIELDS IN PLACE.
GARDEZ UNE BONNE DISTANCE ENTRE VOUS
ET LES PERSONNES ENVIRONNANTES.
N’ENLEVEZ PAS LA TÔLE PROTECTRICE.
3. BEFORE WORKING ON MACHINE DISENGAGE
POWER, SHUT-OFF ENGINE AND MAKE SURE
AUGER HAS STOPPED ROTATING.
AVANT TOUTES RÉPARATIONS, ENLEVEZ LE
CONTACT, ARRÊTEZ LE MOTEUR ET
ASSUREZ-VOUS QUE LA VIS HÉLICOЇVALE
NE TOURNE PLUS.
DANGER
To prevent serious injury or death from
moving parts:
Close and secure guards and shields
before starting.
Keep hand, feet, hair and clothing away
from moving parts.
Disconnect and lockout power source
before adjusting or servicing.
Do not stand or climb on machine when
operating.
WARNING
MOVING PART HAZARD
Colour: Red
Location: Blower Side
Colour: Orange
Location: Blower Side