Nostalgia BSET300 SERIES Instruction Manual - Helpful Tips

E

N

G

LI

S

H

8

COFFEE MAKER

1. 

Put desired amount of coffee grounds into Coffee Filter 

and place Coffee Filter inside of Filter Basket. 

2. 

Pour desired amount of clean, cold water into the Water Tank. 

Never exceed the maximum level indicated.

3. 

Make sure that Coffee Pot is on burner. 

4. 

Close Coffee Maker Lid and flip Selector Switch to the COFFEE/3 in 1 position.

5. 

While coffee is brewing, DO NOT open Coffee Maker Lid as this could cause scalding.

6. 

When coffee has finished brewing, flip Selector Switch to COFFEE OFF position.

7. 

Unplug appliance when finished and allow hot plate beneath 

Coffee Pot to cool completely before cleaning. 

8. 

Coffee maker is equipped with a non-drip valve that will automatically 

operate to stop drops of coffee dripping onto the hotplate. However, if any 

coffee splashes or drips onto the hot plate beneath the Coffee Pot, clean it 

with a dry, non-abrasive cloth after appliance has cooled completely.

HELPFUL TIPS

BURNING/SMOKING

If the machine is burning or smoking during cooking, turn all knobs 

and switches to the OFF position to end the cooking cycles. 

Smoking may also be caused by excess crumbs or grease stuck inside the machine. 

To prevent smoking, make sure to empty and clean the Crumb Tray after each use.

NONSTICK SURFACE

It is normal for appliances with nonstick coating to emit a slight odor and smoke 

during the first few uses. The odor and smoking should dissipate with normal usage. 

Remember to always coat nonstick surface with vegetable oil 

before each use to protect the nonstick finish.

CLEANING & MAINTENANCE 

Make sure the unit is unplugged before cleaning. Allow all parts to COOL to the 

touch, especially the Toaster Oven, Griddle Plate, Coffee Pot and Crumb Tray.

To prolong the life of your 3-IN-1 BREAKFAST STATION, please follow these simple 

instructions for maintenance. Never place the appliance in a dishwasher.

•

Make sure the 3-IN-1 BREAKFAST STATION is unplugged and 

completely cooled before storing or cleaning.  

•

Remove Griddle Plate, Wire Rack and Crumb Tray. Wash them using warm, soapy water 

and a non-abrasive sponge or cloth. Dry thoroughly with a dry, non-abrasive cloth.

•

Clean outer surface of the 3-IN-1 BREAKFAST STATION with a dry, non-

abrasive cloth when it is unplugged and completely cooled.

•

Clean interior of the Toaster Oven with a damp (not wet), non-abrasive cloth. DO NOT use a 

scouring pad on the interior of the Toaster Oven. Dry thoroughly with a non-abrasive cloth.