Nothern Industrial Tools Plasma 275 Operator's Manual - page 9
8
Plasma Cutter
Operating Instructions and Parts Manual
Plasma Cutter
Plasma 275
4. Line the electrode and nozzle and
slide on.
5. Install the cover to the torch and
screw on.
INSTALLING THE TORCH
1. Connect the red cable with the red
terminal on the front side of the
plasma cutter.
2. Connect the torch control cable to
the black, round, 3-pronged
connector on the front of the plasma
cutter. Be certain to properly align the
knotch in the connector with the
grove in the plug.
3. Connect the torch to the negative (-)
receptacle.
4. The right connection
5. Connect the grounding cable to the
positive (+) receptacle.
6. Illustration of Complete
Assembly
Operation
High voltage danger from power
source! Consult a qualified
electrician for proper installation of
receptacle at the power source.
This cutter must be grounded
while in use to protect the operator
from electrical shock. If you are
not sure if your outlet is properly
grounded, have it checked by a
qualified electrician. Do not cut off
the grounding prong or alter the
plug in any way and do not use
any adapters between the cutter’s
power cord and the power source
receptacle. Make sure the POWER
switch is OFF then connect your
welder’s power cord to a properly
grounded 120 Vac ,
(grounding)
1-Phase Power
Air Compressure
Control Cable
Torch Trigger
Earth Cable Work Piece
Power Supply
Torch
1-120V
Pilot Arc Cable
Interface
Torch Cable
Switch
Connector for Torch Control Cable
Output Connector for Torch
Connector for Grounding Cable
Conntector for Pilot Arc Cable
Gournding Clamp
Quick Connector