Nova Gear NG-51 Instruction Manual - Intended Use

6

OVER DISCHARGE PROTECTION

An internal component of the 

battery pack is an over discharge 

protector. This feature will stop the 

battery from discharging beyond the 

recommended lowest safety voltage.

OVER HEAT PROTECTION

The battery has an internal Thermister 

cut off sensor which will cease the 

charging cycle if the battery becomes 

hot during the charging process. This 

Thermister sensor will also stop the 

battery from operating should the 

battery become too hot during the 

operation of the tool. This can happen 

when the tool is overloaded or being 

used for extended periods of time.

Up to 30min in cooling time may 

be required depending on ambient 

temperature and operation being 

performed.

OVER CURRENT PROTECTION

Should the battery be overloaded 

and the maximum current draw be 

exceeded the battery will temporarily 

stop working to protect the internal 

components. The battery will resume 

to normal operation once the

excessive current draw has returned 

to normal safe level. This may take a 

few seconds.

SHORT CIRCUIT PROTECTION

If the battery pack was to short circuit 

the short circuit protector would 

immediately stop the battery pack 

from operating. This will ensure that 

no further internal components of the 

battery or the tools are damaged.

INTENDED USE

The LED torch is designed to light up 

work areas.

This tool is to be used only for its 

prescribed purpose. Any other use 

is deemed to be a case of misuse. 

The user / operator and not the 

manufacturer will be liable for any 

damage or injuries of any kind caused 

as a result of this.

never overcharged. When the battery 

has reached its full charge capacity 

the charger will shut off protecting the 

internal components of the battery 

from being damaged.