NovaGear NG-210 Instruction Manual - Set-Up And Adjustments
9
SET-UP AND ADJUSTMENTS
3. The Mitre Saw has been shipped with the
cutting head in the locked down position.
To release the cutting head, push down on
the operating handle, pull the head locking
pin and gently raise the cutting head.
TRANSPORTATION
Ensure the Mitre Saw is turned off and
disconnected from the power source
before transporting. Lift the Mitre Saw only
when the cutting head is in the locked
down position. Only lift the Mitre Saw by the
carry handle or outer castings. Do not lift
the Mitre Saw using the retractable safety
guard or the operating handle.
BENCH MOUNTING
The base of the Mitre Saw has four bench
mounting holes that can be used to mount
it to a workbench or mitre saw stand.
1. Mount the Mitre Saw onto a workbench
or mitre saw stand. Ensure the surface is
level and balanced.
2. Use four screws and bolts (not included)
to secure the Mitre Saw to the workbench
or mitre saw stand.
NOTE:
If required, the Mitre Saw can be
mounted onto a 13mm piece (or thicker) of
plywood which can then be clamped to the
work bench or mitre saw stand. This
UNPACKING
1. Remove the packaging materials from
around the Mitre Saw and remove all parts
from the packaging.
2. Using the carry handle (Fig. 1), carefully lift
the Mitre Saw from the packaging and place
it on a level work surface.
Warning:
Do not lift the Mitre Saw
whilst holding on to the guards. Use
the carry handle.
!
Fig.1
Head locking pin
Fig.2
Fig.3