Lingo ® electronic assembly installation instructions doc. #569066000—b 7/30/04 printed in u.S.A..
Regulatory compliance safety this device has been tested and found to be in compliance with the requirements set forth in ul 916, energy management equipment, and is listed by underwriters laboratories, inc., for installations in the united states. This device has been tested and found to be in comp...
Description the lingo ® energy infosystem is the next generation control processor that functions as a system network manager and control monitor in novar controls corporation’s advanced building control system. Lingo monitors and logs the operations of the local control modules, manages network com...
Precautions take the following precautions during installation: § observe national and local electrical codes. § connect 24-vac power wiring to the terminals marked as 24 vac only. Connection to other terminals will damage them. § do not use the lingo as a final safety device. § make sure that the 2...
Installing the lingo electronic assembly on the baseplate use the following procedure to install the lingo electronic assembly on the baseplate. Step procedure 1 remove the baseplate’s cover. § use the hex wrench supplied in the hardware kit to loosen the two screws at the bottom of the baseplate. §...
Checking installation note! The system programming must be downloaded to the lingo panel before the installation can be checked. Once the system programming has been downloaded, the installation can be checked locally or remotely. Locally to check the installation locally, use the optional touchscre...
Model and part numbers use the part numbers supplied in table 1 to order the necessary novar controls parts. Table 1. Novar controls part numbers product model no. Part no. Lingo baseplate lingo-bpl 750100000 lingo electronics assembly (no options) options: lingo with integral touchscreen lingo with...
This page intentionally left blank. 6 doc. #569066000—b 7/30/04 lingo electronic assembly installation instructions.
