NovaSail NS-START POCKET V2 Operating Manual - Pc Mode
16
PC Mode
The PC mode is activated to exchange data between the
Bluetooth wireless transceiver and the computer.
The "NS-START Pocket V2 Wireless Manager" software allows you to check the
communication status, upgrade the embedded firmware & setup the device.
Please refer to the Novasail Wireles Manager documentation for more details; the
online manual can be open with a right click on the "NS-START Pocket V2
Wireless Manager" main window.
To enter in PC connectivity mode
•
With the product switched off, press first
then
simultaneously. “PC”
is displayed on the data line of the upper screen (blinking) (blinking) with
“blu” (bluetooth) shown
•
To exit the PC mode, press and hold the button
.
Troubleshooting
•
Make sure the Bluetooth connectivity is activated on the PC
•
Make sure to allow any Bluetooth device to find the PC in the operating
system
•
Close/re-open the "NS-START Pocket V2 Wireless Manager" app. Remove
the
from the previously paired bluetooth
devices and launch a new pairing process
•
Make sure the PC mode on the
is turned on:
“PC” must be blinking on the main display and “blu” (Bluetooth) must be
shown on the lower line
•
Confirm the
is indicated on the available
Bluetooth devices on the PC
•
The message ’connected’ should appear in green at the bottom of the "NS-
START Pocket V2 Wireless Manager" window within a minute (the delay is
PC hardware dependant)
Note:
to save batteries the
will shut down
automatically if no PC connectivity is detected for 10 minutes.