All intellectual property rights involved in this document belong to xi’an novastar tech co., ltd., whose rights are reserved. Psd100-wifi quick start guide stable reliable powerful quality rev1.0.0 ns120110045.
- 1- psd100-wifi features 1) wireless communication with wifi module :support ap mode, station mode and ap + station mode; 2) remote publish play-program, monitor the current play information and control power supply; 3) play as period or according to date, week and time; 4) support a variety of med...
- 2- hardware introduction prompt: 1) please do not directly switch psd100-wifi into local area networks by network cables at the time of dhcp opening. As the dhcp of this card will conflict with the dhcp service for routers in the local area network at the time of opening and meanwhile, ip addresse...
- 3- mode i: wifi control card does not connect with external network. Prompt: in this case, devices at the distribution and management terminals cannot get on the internet. 1) connect psd100-wifi to user computers by network cables; 2) set computer's ip address as static ip: 192.168.10. *; 3) open ...
- 4- mode ii: connect the wifi card with external network by wireless network: 1) set computer's ip address as static ip: 192.168.10. *; 2) open the browser and input 192.168.10.1 in the address bar, to enter the setting interface of wireless routers. Both the login user and the password are admin b...
- 5- mode iii: connect the wifi card with external network by network cables: prompt: please close the dhcp service before setting wireless network parameters. Connect psd100-wifi to external routers by network cables and then use mobile devices for wifi hot spots searching: the ssid is nova****** (...
- 6- 2) after configuration, reset computer ip as automatic acquisition, select wireless setting -> scan hot spots and determine the hot spot for connection. The topological graph of bridge connection mode is as shown below; prompt: please refer to the psd100-wifi user guide for mode bridge connecti...
- 7- 2) after required display is complete, click connect display; 3) click user -> advanced login, enter the password "admin" and click for logging in; 3 led display lightening 1) click led screen configuration on the lct homepage; 2) click smart setting on the left lower corner in “scan board” pag...
- 8- 3) select option 1 and click next for starting smart setting; 4) conduct led display lightening as per smart setting wizards. Prompt: please log in the website of novastar (www.Novastar-led.Com) and review the novalct-pluto user's manual in the download center, for detailed introductions to the...
- 9- the novalct-pluto user's manual in the download center, for detailed introductions to the operations of cascading scan board. 5 programming and publishing programming: install and run the plutomanager and select the editing mode as billboard. Click "create playlist" to enter the interface as sh...
- 10- publishing: program publishing includes publish standard playlist, publish temporary content，publish immediate notification. In the primary interface of plutomanager, click the publish playlist or directly click the publish key in the play-program creating page to enter the playlist publishing...
Xi'an novastar tech co., ltd. Http://www.Novastar-led.Cn floor 2, block d, qinfeng pavilion, xi'an software park, 2 nd keji road, high-tech zone, xi'an,710075,shannxi china.
