Novatac 120P User Manual - page 7
Option 7: Simple Momentary
The Simple Momentary option allows a press to be distinguished from a click when
your light is turned off. When the Simple Momentary option is enabled, your light
turns off when the button is released following a press. When the Simple Momentary
option is disabled, your light will stay on after the button is released following a press.
The Simple Momentary option is a toggle setting. Setting it once enables it while setting
it twice disables it. The default setting is disabled.
The Simple Momentary option is the seventh item in the Option menu and is identified
by a short flash followed by a long flash.
Option 8: Tactical Momentary
The Tactical Momentary option provides a pure momentary mode of operation – i.e.,
when the button is pushed the light is on and when the button is released the light is
off. Therefore, you must make any desired configuration changes before enabling the
Tactical Momentary option. If the Automatic Button Lock option is enabled, the button
locks upon enabling the Tactical Momentary option and your light remains dark when
the button is pressed. Further, upon releasing the button lock, your light remains off
until the button is pressed again.
Note: performing a soft-reset will force the button to lock when both the Tactical
Momentary option and the Automatic Button Lock option are enabled.
You disable the Tactical Momentary option by performing a factory-reset. The default
setting is disabled.
The Tactical Momentary option is the eighth item in the Option menu and is identified
by two short flashes followed by a long flash.
Option 9: Ramping and Option Menu
The Ramping and Option Menu option turns on the brightness level ramping and the
Option menu. Disabling this feature prevents further configuration changes.
You re-enable the brightness level ramping and the Option menu by performing a
factory-reset. The default setting is enabled.
The Ramping and Option Menu option is the ninth item in the Option menu and is
identified in the Option menu by a brightening sequence.
Resetting Your Light
You must perform a reset to disable Tactical Momentary after it is enabled, to enable
brightness level ramping and the Option menu after they are disabled, to restore factory
settings or when you change the type of batteries you are using. A reset can also be
used to regain control if your light ever gets into an unresponsive state.