195.5501 – air 5” 195.5701 – air 7” 195.5551 – electric 5” 195.5751 – electric 7” shrouded right angle grinder 5” & 7” operations and maintenance.
Operation and maintenance manual for shrouded right angle grinders 5” and 7” for professional use only important safety information enclosed. Read and understand this manual before operating this product. It is your responsibility to make this safety information available to others that will operate...
• electrically powered tools are not insulated against electric shock. • be aware of buried, hidden or other hazards in your work environment. Do not contact or damage cords, conduits, pipes, or hoses that may contain electrical wires, explosive gases or harmful liquids. • keep hands, loose clothing...
Table of contents section i general .......................................................................................................................................... 6 section ii before use ........................................................................................................
Section i general this operation and maintenance manual is furnished with each r/a shrouded grinder tool purchased. It outlines the general operation and maintenance items critical to insure satisfactory, safe and long life of the r/a shrouded grinder and accessories. Read all instructions and data ...
- check the r/a gear drive by rotation the output shaft to determine any roughness in the bearing or gear meshing during rotation. If roughness is indicated, inspect the tool per the corrective action section of this manual. Periodic inspections and maintenance requirements electric motor arcing bet...
Shroud assembles - at intervals of no more than 50 hours of operation, or weekly, clean the tool externally and internally by removing the shroud end plate. Inspect the hub assembly and cutting flap units and cutter heads for wear and damage. - use a high flash point solvent to flush debris. - repla...
I. To disassemble the angle head assembly, grip casting in soft jaws, unscrew bearing housing and withdraw whole spindle assembly unit. J. Remove circlip. Remove bearing by sliding into slot “e” in stripper plate, support stripper plate either side of bearing and press out. K. Slide off circlip. Pre...
Tool height (in.) 4.5 5.5 tool width (in.) 6.5 6.5 air press req. (i 10 psi) 90 n/a air consumption (scfm) 30 n/a air inlet fitting (spi) 1/4” male npt n/a electric 110/120v - 10amp service layout #1 the following parts list is included to identify parts from the service layout be reference number a...
9 312.A101 rotor spacer 10 312.A604 bearing 11 312.A689 bearing 12 312.A722 bearing 13 312.A723 bearing 14 312.A605 bearing 15 312.A725 spindle 16 312.A100 circlip 17 312.A142 circlip 18 312.A724 bearing housing 19 312.A726 gear wheel 20 312.A727 pinion 23 312.A104 back nut 24 312.A249 oiling screw ...
Service layout # 2 the following two tool service layouts, with referenced part numbers, are used throughout this manual to help identify parts and location for disassembly, assembly and general service procedures. The first layout covers the r/a air motor assembly and the second layout covers the r...
Floating head shroud and cleaning pad assemblies part numbers: 195.5501, 195.5551, 195.5701, 195.5751.
Novatek corporation limited warranty the tools manufactured/distributed by novatek corporation are warranted to be free from defects in material and workmanship for a period of one year with the exception of electric drive units, electric motors and air blowers - 6 months warranty applies on the ele...
