«novatek-electro» ltd intelligent industrial electronics multifunctional two-channel time delay relay rev-201 М operating manual review the operating manual before using the unit. Www.Novatek-electro.Com.
- 2 - rev-201М novatek-electro store the unit in the operating environment for 2 hours before switching to the mains. Never attempt to remove and repair the unit. Some of the unit components may be live. Never attempt to operate the unit with the mechanical damage of the housing. The unit is not des...
- 3 - novatek-electro rev-201М this present manual contains necessary information about application, main operation principles and adjustment setting for the two-channel electronic time delay relay rev-201m (hereinafter rev-201 М). 1 general description and operation 1.1 application rev-201m is desi...
- 4 - rev-201М novatek-electro time setting adjustment smooth number of scale marks for the potentiometer knobs 10 type and quantity of the output commutation terminals 1 changeover protection degree: - housing - contact terminals ІР40 ІР20 commutation lifetime of the output terminals at cos =1: - u...
- 5 - novatek-electro rev-201М rev-201m complies with requirements: iec 60947-1:2004, ІdТ ; Іec 60947-6-2:1992, Іdt ; iec 61000-4-2:2001, idt ; cispr 11:2004, idt pollutants in the amount, which is not to exceed the maximum permissible concentration are none 1.3.2 front panel view and outer dimensio...
- 6 - rev-201М novatek-electro 1.2.3.3 “ intermittent 1” operation mode in the figure 4 there is represented the working algorithm of relay " intermittent 1 ”. Figure 4 – the working algorithm of relay “ intermittent 1” time counting on each channel starts from the moment of power supply to the term...
- 7 - novatek-electro rev-201М attention!!! - in this mode of operation time adjustment knobs (t1 and t2) as well as the dip switched for the time ranges (d1 and d2 ) doesn’t function. All timing frames and intervals are preprogrammed and fixed. On special customer request for the algorithm “start-p...
- 8 - rev-201М novatek-electro note – if the time interval of potentiometer Т1 is equal to zero, the load relay will not switch over. 1.3.3.7 turn-off delay figure 8 shows the relay operation algorithm for “turn-off delay”. Figure 8 – the working algorithm of relay “turn-off delay” after voltage sup...
- 9 - novatek-electro rev-201М table 2 № operation mode А description 1 turn on time delay after the power supply application rev-201m performs user preset time delay t1+t2 that will be followed by opening of the output contacts and rev-201m will switch to idle state. 2 impulse 1 after power supply ...
- 10 - rev-201М novatek-electro 4 0 – 1 min 0 – 10 min 5 0 – 10 min 0 – 100 min 6 0 – 100 min 0 – 1 hour 7 0 – 1 hour 0 – 10 hours 8 0 – 10 hours 0 – 20 hours notice: note – when arranging the time settings by the potentiometers 2, 3 (figure 1) it is necessary to note that there is so called “dead” ...
- 11 - novatek-electro rev-201М 3.1.2 do not expose the inner electric components of the unit, as well as input contacts of terminal blocks and sockets, to water. 3.1.3 switching, adjustment and maintenance of the unit should be conducted by the qualified personnel, who is familiar with the provisio...
