O2 JET User Manual - page 104
200
or damage to the camera lens) unless the defect was caused
directly by defects in materials or workmanship. This Limited
Warranty does not cover physical damage to the surface of the
Products including cracks or scratches on the LCD screen or
camera lens; or
e. the Product serial number or IMEI number has been removed,
defaced, altered or is illegible; or
f. the defect was caused by a defective function of the cellular
network; or
g. the defeat was caused by the fact that the Products were used
with or connected to an accessory not approved or provided by
O2 or used in other than its intended use and where it can be
shown by O2 that such defect is not the fault of the Products.
h. repairs performed by service centres that have not been
authorised by O2.
8. In the event of Product failure, the customer should take the
following actions:
a. Refer to the user manual in order to identify and possibly
correct the problem.
b. If the problem cannot be resolved by reference to the user
manual the Customer should return the Product to the place
where it was purchased.
9. THIS LIMITED WARRANTY STATES THE ENTIRE WARRANTY
GIVEN BY O2 TO THE CUSTOMER. IN NO EVENT SHALL O2
BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL LOSSES OR
5. If O2 repairs or replaces any Products, the repaired or replaced
Products shall continue to be warranted for the remaining time
of the original Warranty Period or for three (3) months from the
date of repair or replacement, whichever is longer.
6. Before returning any Device, you are responsible for ensuring
that you back up data and remove any personal information
from the Device. O2 is not responsible for any loss of data or
removable storage media.
7. THIS WARRANTY SHALL NOT APPLY IN THE FOLLOWING
CIRCUMSTANCES:
a. O2 or its authorised agent was not notified by the Customer of
the defect within fourteen (14) days after the appearance of the
defect within the Warranty Period; or
b. the Products were not returned to O2 or its authorised service
agent within (30) days after the appearance of the defect within
the Warranty Period; or
c. deterioration of the Products due to normal wear and tear; or
d. use other than in accordance with the user manual; rough
handling; exposure to moisture; dampness or extreme thermal
or environmental conditions or a rapid change in such
conditions; corrosion; oxidation; unauthorised modifications or
connections; unauthorised opening or repair; repair by use of
unauthorised spare parts; accidents; forces of nature; or other
actions beyond the reasonable control of O2 (including but not
limited to deficiencies in consumable parts, such as batteries
which all by their nature have a limited lifetime, and breakage
199