Oakley 3U User Manual - page 9
Onboard Pots
All pots Alpha 16mm
47K Lin or 50K Lin
BALANCE
100K Log
GAIN
10K Lin
TIMBRE
The TIMBRE and BALANCE pots have space to mount pot brackets.
Note that when fitting the GAIN pot, which has no pot bracket, a shim washer should be
fitted between the pot and the inside of the front panel. You can use the washer provided with
the pot for this purpose or get another one of similar size so that you can use the provided
washer on the outside like you would normally.
Wire link
Fit a small hoop of uninsulated wire (resistor lead clipping) into the two holes of LK. This
joins the two ground pins of the 4-way 0.156” header.
Miscellaneous
Leaded Ferrite beads
L1, L2
Double pole changeover switch
SW1/2
4-way 0.1” Molex/MTA header
SKT
And one of the following:
4-way 0.156” Molex/MTA header
PWR For +/-15V systems
2x5-way 0.1” header
PSU
For +/-12V systems
3.5mm sockets
Two off mounted off board
You'll also need solder, two lots of about 75cm of insulated multistrand hook up wire, each of
a different colour, and a couple of cable ties.
You may well want to use sockets for the ICs. I would recommend low profile turned pin
types as these are the most reliable. You need two 8-pin DIL sockets.
9