Oakton 35622 Series Operating Instructions Manual

Summary of 35622 Series

  • Page 1

    Operating instructions oakton ® 35622-series printer printed in the u.S.A. 9/97 on distributed by: 9. Warranty oakton instruments warrants this product to be free from significant deviations in material and workmanship for a period of one year from the date of purchase. If repair is necessary and ha...

  • Page 2

    2 3 table of contents 1. Introduction ........................................................................................................3 2.. Features and functions..................................................................................4-5 2.1 interface..................................

  • Page 3

    5 4 2. Features and functions interface this printer supports standard rs-232 serial interface only. The baud rate is selec- table for 1200, 2400, 4800 or 9600 baud. The data bits can be set at 8 or 7 bits with 1 or 2 stop bits, with none, even or odd parity. The printer’s factory default settings a...

  • Page 4

    3. Preparing to print the printer ribbon, paper roll, and rechargeable battery pack are loaded in the print- er before packing. When the printing becomes faint, see section 3.1 on how to load a new ribbon into the printer. When the paper runs out, see section 3.2 on how to load paper into the printe...

  • Page 5

    9 loading paper 1. To load paper, first lift the cover plate. 2. Cut the end of the new paper roll into a point. (figure 3.2.1) 3. Place the paper roll inside printer case. The cut end of the paper must be underneath the roll. (figure 3.2.2) slide the cut end of the paper between the two metal plate...

  • Page 6

    10 11 4. Setting up printer parameters selecting meter type and communication parameters when shipped, the printer is set to print output from the oakton 200 series ph hand-held meter. If you are using the oakton ph 2000 or ph 2500 benchtop meter, or the con 100 hand-held conductivity meter, follow ...

  • Page 7

    13 12 9. Press the ▲ key to select on. 10. Press the print button to print out the calibration parameters. Note: if there are no previous calibration parameters stored in the meter, the err indicator will flash. To return to printing data with your benchtop meter: 1. Switch the printer off. 2. Press...

  • Page 8

    14 15 7. Troubleshooting loading the ribbon sometimes, although cassette is put in correctly, part of the ribbon rides up over the printer head. This may be caused by two reasons: 1. The paper has caught on the ribbon. Remove paper and reload according to section 3.2. 2. The ribbon has been used for...