OAKWORKS GMCTMP Instruction Manual

Manual is about: Celesta Gemini spa table

Summary of GMCTMP

  • Page 1

    I n s t r u c t i o n m a n u a l o akworks ® instruction manual manual part # mmmncg0109 edition 3, english may 2007 printed in u.S.A. ® massage tables 64ca.

  • Page 2

    ? 2005 o akworks ® , inc. Manual part # mmmncg0109 edition 3, english may 2007 all rights are reserved. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of o akworks ® , inc. O akworks ® is a registered trademark of o akworks ® ,...

  • Page 3

    Warranty statement all warranties are limited to factory-provided replacement parts, factory repair or replacement, at the discretion of o akworks ® . All warranties exclude damage caused by improper set-up, accident, abuse, misuse, neglect, use for other than intended purpose or reasonable wear suc...

  • Page 4

    Ii symbol identification • how to care for your upholstery symbol identification fluoroscopy table part no. Description 2378 column dl1(4) 2379 cable, motor (1) 7324-1 control box, master (1) 7324-2 control box, master / eu (1) 7324-3 control box, master / japan (1) 7328-1 control box, slave (1) 732...

  • Page 5

    Specifications model no. Gmctmp designed for: north america europe/switzerland united kingdom australia japan/korea voltage/current service available input frequency voltage output current consumption w/o internal outlets electric shock protection mode of operation storage & transport * measurements...

  • Page 6

    Improper use of this device can cause injur y. Be sure to read all operating instructions prior to use to prevent injury to operator or client. Electrical shock hazard. To reduce the risk of electric shock, always disconnect the table from the electrical outlet before moving the table or doing any m...

  • Page 7

    V warnings w arnings warnings & important safety instructions 22 care & cleaning • how to care for your upholstery care & cleaning how to care for your upholstery: in order to maintain the quality and ensure the life of the c elesta g emini ™ , here are some preventative steps that can be taken to p...

  • Page 8

    Vi warnings & important safety instructions grounding instructions w arnings & safety instructions grounding instructions 8. Plug the new foot control into the control box bracket at the same connection where the inoperable unit had been. 9. Carefully lift the control box, mounting bracket and exces...

  • Page 9

    1 introduction • c elesta g emini ™ introduction introduction c elesta g emini ™ o akworks ® c elesta g emini ™ offers a variety of positioning capabilities for massage therapists and skincare professionals of all specialties. On this multi- functional professional model table the practitioner can p...

  • Page 10

    Foot control replacement instructions replacement of the foot control may be necessary if the control does not actuate the functions of raising or lowering the c elesta g emini ™ . Once the replacement unit has been received you are ready to replace the inoperable foot control. To replace the foot c...

  • Page 11

    3 product description • c elesta g emini ™ product description ta b l e s p e c s * : • height *: 25" - 37" • width: 31" • length: 72" • lift capacity: 625 lbs maximum working load • weight: 300 lbs. • top: electronically controlled easy access design top • electronics: 1 hand control & 1 foot contr...

  • Page 12

    4 inst alla tion installation installation • leveling instructions the c elesta g emini ™ comes completely assembled and ready to use. Plug the cord into a functioning outlet that is rated for the table. Arrange the power cord and control cords so that they will not create a tripping hazard. Place t...

  • Page 13

    16 troubleshooting • if c elesta g emini ™ will not change height or position • hand control replacement troubleshooting i f the c elesta g emini ™ will not change height or position : • check the outlet to be sure that it has power and that the power cable is plugged in. Try each foot control and h...

  • Page 14

    6 directions for use • adjusting height and top positions of the c elesta g emini ™ using the hand control directions for use c elesta g emini ™ hand control operations • c elesta g emini ™ back rest control: - activates backrest up to 64Þ back rest control: - activates backrest down to level positi...

  • Page 15

    When operating the c elesta g emini ™ controls and making any and all adjust- ments to the table, move hands and feet away from the working mechanism of the table. Height control: - raises table height height control: - lowers table height press and hold the appropriate button until the position des...

  • Page 16

    Pre-set positions hand control operations • c elesta g emini ™ position 5: - full horizontal position position 6: - reclined with leg rest at low incline position 8: - upright position with leg rest at mid-incline position 7: - slight recline with leg rest at low incline 5 6 7 8 c elesta g emini ™ d...

  • Page 17

    12 directions for use • use & adjustment of the c elesta g emini ™ ar m rests directions for use directions for use to remove one or both arm rests just take hold of the base of the arm rest at the metal frame and somewhere on the cushion. Holding secure- ly, rotate the arm rest while at the same ti...

  • Page 18

    To access the storage in the under table cabinet: (cont) of the table, slide independently along this track with slight pressure on the handles found in the center of each door. They will open until they are completely inside the cabinet; stopping when the handle meets the handle recess in side of t...