Oase FiltoClear 12000 Operating Instructions Manual

Other manuals for FiltoClear 12000: Operating Instructions Manual

Summary of FiltoClear 12000

  • Page 1

    Filtoclear 12000/16000/20000/30000

  • Page 2

    2.

  • Page 3

    3.

  • Page 4

    4.

  • Page 5

    5.

  • Page 6

    6.

  • Page 7

    7.

  • Page 8

    8.

  • Page 9

    18 - gb - translation of the original operating instructions information about these operating instructions welcome to oase living water. You made a good choice with the purchase of this productfiltoclear 12000/16000/20000/30000. Prior to commissioning the unit, please read the instructions of use c...

  • Page 10

    19 - gb - unit configuration and function description unit configuration figure (b) object 1 water return socket, for the return of filtered pond water 2 water inlet socket, for the inlet of soiled pond water 3 cleaning handle, the foam filters are compressed by pulling the handle up 4 uvc unit head...

  • Page 11

    20 - gb - oase recommend: − as a filter starter: oase biokick. − as a reference value for the fish population in the pond: approx. 60 cm fish length in 1 m³ pond water. − as a pond pump for filtoclear 12000: aquamax eco 8000. − as a pond pump for filtoclear 16000: aquamax eco 10000. − as a pond pump...

  • Page 12

    21 - gb - − the power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to be disposed of. − only operate the unit if no persons are in the water! − the unit, the connections and plugs are not water-proof and must not be routed or installed in water. − ...

  • Page 13

    22 - gb - installation figure (c) 1 ½" hoses or 2" hoses can be connected to the unit. The respective hose connectors are part of our scope of delivery. Recommendation: use 2" hoses to convey the water through the lines at a minimum pressure loss. If you use a filter starter, fill the product into t...

  • Page 14

    23 - gb - commissioning/start-up attention! Sensitive electrical components. Possible consequence: the unit will be destroyed. Protective measure: do not connect the unit to a dimmable power supply. Oase recommends the use of biokick (oase filter starter bacteria): − for the initial start-up − after...

  • Page 15

    24 - gb - maintenance and cleaning removing/inserting the uvc unit head attention! Dangerous electrical voltage. Possible consequences: death or severe injury. Protective measures: switch off the mains voltage prior to carrying out work on the unit. Removing the uvc unit head figure (e) how to proce...

  • Page 16

    25 - gb - − vigurously pull up the cleaning handle (3) several times, then push the handle down against the stop ("pumping" action). The foam filters will be rinsed by this action. − as soon as only clean water appears in the transparent hose connector (20), turn the function switch (5) counter- clo...

  • Page 17

    26 - gb - replacing the uvc lamp attention! Dangerous electrical voltage. Possible consequences: death or severe injury. Protective measures: isolate the unit prior to reaching into the water and carrying out any work on the unit. Secure the unit from being switched on inadvertantly. Attention! Brea...

  • Page 18

    207 tech nisch e dat e n de t yp abm es s ungen g ewic ht bem es s ungs s pannun g leis tu ngs auf na hm e kab el län ge ans c hlüs s e f ilter vo lum en uvc- lam pe m a x . T eic hvolum en w a ss er te m per atur gb t ype dim ens ions w eight rated v olt age po w er c o ns um ption cabl e l eng th ...

  • Page 19

    208.

  • Page 20

    209.

  • Page 21

    210