Installation / operation manual fstb-a series brewers oasis corporation 265 n. Hamilton road p. O. Box 3150•columbus, oh 43213-0150 1-800-64-oasis (1-800-646-2747) www.Oasiswatercoolers.Com fstb-a60 *fstb-a60c length 20-1/2 height 16-7/8 width 9-7/8 1430 watts 12 amps 120 volts *model includes caraf...
Caution: read installation / operation instructions prior to installing and operating the freshstart brewer a. Inspection brewer comes complete with brew basket, detachable power cord and installation/operation manual (carafe may be included, but is sold separately). 1. Inspect the carton and brewer...
A. Energize brewer / hot tank heat up 1. To power up brewer and start the hot tank, push the on/off main power switch, at rear of the brewer, to the on position (see figure 2). 2. Turn the front control panel on by pressing the on/off brew cancel button. The red light above this button will illumina...
Operation instructions b. Cancelling a brew cycle to cancel a brew cycle that is in process, press the on/off brew cancel button located on the front control panel. When canceling a brew cycle, water is shut off to the spray head, but the brew basket will continue to drain until depleted. C. Cup dra...
Service instructions b. Cleaning the sprayhead over time mineral build up may develop around the (6) spray holes on the spray head which may lead to pot volume variances. Periodic inspection and cleaning of the spray head is recommended. 1. Turn spray head counter clockwise a quarter turn until it s...
D. Servicing the mechanical floats resetting the safety float 1. Remove cover from cabinet. 2. Press down on the safety float re-set button (see figure 8). Float arm inspection 1. Remove float cap from top reservoir. 2. Float arms should move up and down freely and should not bind or catch (see figu...
G. Thermostat replacement (continued) limiter control (see figure 11) 1. Follow steps 1 and 2 from primary thermostat. 2. Remove tank feed and vent silicone tubing from reservoir bottom. 3. Remove upper reservoir by releasing the (3) clips. 4. Remove both wires from limiter thermostat. 5. Using a ¼ ...
Problem resolution trouble shooting guide brew cycle will not start • check that the power cord is properly plugged into the iec receptacle located at the back of the brewer (see figure 5). • check that the power cord is plugged into a proper electrical outlet (see service instructions section c). •...
