OBaby 10DB0702 Instructions Manual - page 5

Fitting and Removing the Hood

Adjusting the Hood

fig. 24

fig. 27

fig. 27a

fig. 25

fig. 28

fig. 28b

fig. 26

fig. 29

fig. 29c

To open or close the hood, pull or push the hood as shown above. (fig.27-29)

To extend the hood, first unzip the first section of the hood (fig.27a). Then pull hood 

forward and down untill fully extended (fig.28b-29c). To close do the reverse.

fig. 30

fig. 33

fig. 31

fig. 34

fig. 32

fig. 35

fig. A

Using the Harness

Press

To fit the hood, place the hood on the chassis, inline with the seat unit. Clip the hood 

onto each side of the chassis (fig.24). Attach using hook and loop tape around chassis 

(fig.25). To remove the hood, lift the lever on each side to release the clips (fig.26).

Waist

Strap

Crotch

Strap

‘D’ Ring

Shoulder

Strap

Clasp

Harness 

Positions

Lower

Inner

Inner

Outer

Outer

Outer

Upper

To fasten the harness, clip each chest strap onto the waist 

strap (fig.30) and insert both fasteners on the waist strap 

into the clasp on the crotch strap (fig.31 & 32).

To release the harness, press the centre of harness clasp 

(fig.33).

Adjust the harness length using the buckles on each strap 

(fig.34).

‘D’ Ring 

The ‘D’ rings highlighted are provided for fitting a separate 

harness complying with BS 6684 (fig.35).

When using the safety harness from birth, it may be necessary to use the lower holes for 

the shoulder strap and the inner holes for the waist straps and crotch strap.

Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap 

should be used when your child is of a suitable size. (See fig.A)

WARNING: 

Always use the crotch strap in combination with

the waist belt

8

9

www.obaby.co.uk

www.obaby.co.uk