OBaby Edge Instruction Manual - page 5

Fitting and Removing the Bumper

Adjusting the Hood

fig. 24

fig. 27

fig. 25

fig. 28

fig. 26

fig. 29

To adjust the hood, simply move the peak to the desired position, as shown.

fig. 30

fig. 33

fig. 31

fig. 34

fig. 32

fig. 35

Using the Harness

Press

To remove the bumper, press the buttons underneath each side of the bumper (fig.24) 

and pull the bumper away from the chassis (fig.25).

To fit the bumper, simply push the stems on either side of the bumper into the receivers 

on the chassis (fig.25 & 26).

Waist

Strap

Crotch

Strap

Chest

Strap

Clasp

To fasten the harness, insert both fasteners on the waist strap into the clasp on the 

crotch strap (fig.30 & 31).

To release the harness, press the buttons on either side of the clasp and remove the 

waist strap fastners (fig.32).

Adjust the harness length using the buckles on each strap (fig.33) and slide the waist 

strap fastner along the strap (fig.34).

‘D’ Ring 

The ‘D’ rings are provided for fitting a separate harness complying with BS 6684 (fig.35).

WARNING: Ensure the harness is correctly fitted before use.  The harness should 

always be adjusted to fit correctly.  Children should be harnessed in at all times.  

Always use the crotch strap in combination with the waist strap.

Press

8

9

www.obaby.co.uk

www.obaby.co.uk