OBaby Grace Instructions - page 2
Safety Warnings
Safety Warnings
Thank you for choosing Obaby. This cot bed conforms to EN 716 1-2 :2008 + A1:2013
and BS 8509 :2008 + A1:2011. To ensure that your cot bed is used in accordance with
these instructions, please read them fully.
Your child’s safety may be affected if you do not follow these instructions.
WARNING
: A child’s safety is your responsibility.
WARNING
: Assembly should be carried out by a competent adult only.
WARNING
: Do not use more than one mattress in the cot bed.
WARNING
: Do not use the child’s bed near heat sources, windows and other furniture.
WARNING
: Be aware of the risk of open fire and other sources of heat, such as
electric bar fires, gas fires, etc. in the near vicinity of the cot bed.
WARNING
: Do not use this child’s bed if any part is broken, torn or missing. Use only
spare parts approved by the manufacturer.
WARNING
: Do not leave anything in the cot bed or place the cot bed close to another
product, which could provide a foothold or present a danger of suffocation
or strangulation, e.g. strings, blind/curtain cords etc.
• Please be aware that the lowest base position is the safest and the base should always
be used in that position as soon as the baby is old enough to sit unaided.
• The thickness of the mattress chosen should be such that the internal height (surface
of the mattress to the upper edge of the cot frame) is at least 500mm when the base
is set in the lowest position and a minimum of 200mm when the cot base is set in the
highest position.
• We recommend you use the Obaby Mattress Size 140 x 70 cm for this cot bed. The
mattress should be no more then 30mm shorter or narrower than the internal length
or width of the cot bed.
• Regularly check that all fittings and components of the cot/bed are fully tightened and
in working order.
• To prevent injury from falls, as soon as the child is able to climb out of the cot then it
should be changed into the bed mode for use up until 4 years of age.
• The cot bed is designed to be dismantled for storage or transportation.
• Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed
should not be placed to other furniture or windows, and should be placed either tight
to the wall or have a gap of 300mm between the wall and the side of the bed.
• All assembly fittings should be tightened properly and care should be taken to ensure
that no screws are loose, as a child could trap parts of the body, or clothing (e.g.
ribbons, drawstrings, necklaces) this could lead to strangulation.
• During assembly children should be kept away from the product due to possible risk of
injury.
ROUTINE CARE & MAINTENANCE
– For cleaning, use only a mild detergent and warm water.
– DO NOT USE BLEACH.
– DO NOT USE any abrasive substances.
– From time to time, check your cot for loose screws, and worn parts. Replace or adjust
the parts as needed.
Due to constant updating and improvements, some components may occasionally differ
slightly from the images shown in these instructions. We reserve the rights to change
the specifications of any products without prior notice. If you need any assistance please
contact your Obaby retailer from whom you purchased your product, who will take
appropriate action.
2
3
www.obaby.co.uk
www.obaby.co.uk