1. DL manuals
  2. OBaby
  3. Stroller
  4. Retro Minnie
  5. Instruction Manual

OBaby Retro Minnie Instruction Manual

Other manuals for Retro Minnie: Instruction Manual

Summary of Retro Minnie

  • Page 1

    Hood, leg rest & car seat artwork. Please print same size as last samples. Character colours pantone® 410c ears/arms legs hands & eyes tongue face pantone® 162c white pantone® 670c pantone® 630c pantone® 7423c pantone® 630c pantone® 1895c pantone® 630c pantone® 5493c pantone® 630c pantone® 7424c pan...

  • Page 2

    Safety warnings getting to know your highchair tray seat unit harness front leg seat back support bar back leg thank you for choosing obaby. To ensure that your highchair is used in accordance with these instructions, please read them fully. This highchair conforms to bs en 14988:2006 and is guarant...

  • Page 3

    Fitting the legs press the front and rear legs are a different width. Please be aware that the rear leg is narrower at the top, than the front leg (fig.7). Push the front leg a little way into the seat frame tubes at both sides evenly (fig 8 & 9). Push in the spring buttons (fig.10), continuing to p...

  • Page 4

    Folding your highchair to fold your highchair, unfasten the press-stud underneath the tray (fig.19) and unclip the tray from the frame by lifting the tray (fig.20). Lift the tray above the seat (fig.21) and fold the legs together (fig.22). Then lower the tray (fig.23 & 24). Unfolding your highchair ...

  • Page 5

    To fasten the harness, insert both fasteners on the waist strap into the clasp on the crotch strap (fig.25) and clip each chest strap onto the waist strap (fig.26 & 27). To release the harness, squeeze each of the clips in the centre of the harness and pull away from the clasp, one at a time (fig.28...

  • Page 6

    ?disney.