OBaby ZeZu Instruction Manua - page 3
The Handle
The handle has 3 positions:
A - For carrying your child or fitting in the car
B - When fitted on the pushchair or for rocking your baby
C - When used as a seat, eg. for feeding
To move the handle from one position to another, press both release buttons at the same time, move the handle to
the required position, and release the buttons.
Check the handle has clicked into place by gently pushing it.
Always check that the handle is locked and the harness fastened before lifting the car seat.
A
B
C
Positioning the Head Hugger
A head hugger can be used to provide extra support for your
child’s head.
Position the shoulder straps of the car seat through the slots of the
head hugger. Ensure the head hugger is fitted snugly around your
child’s head.
Fitting the Harness
Adjusting the shoulder height
Before putting your child in the car seat, loosen the harness each time so you can fit it properly each time you use
the car seat.
The harness can be loosened by pulling on both straps, at the same time press down on the harness release
button that is located on the shell underneath the ‘PRESS’ word stitched on the car seat cover (fig. 1).
To fasten the harness - slot the shoulder straps together using the two plastic sections (fig. 2). Once these are
connected, slot them into the top of the buckle (fig. 3) so that it clicks into place.
Before tightening the harness, ensure the shoulder straps sit comfortably on the child’s shoulders, and that the
straps are not twisted. The shoulder pads should be positioned so they sit on top of your child’s shoulders, not
just on the chest.
The harness should always be adjusted to fit correctly every time you use the child seat.
To tighten the harness, pull on the adjustment strap until you are happy the harness is tight, but not so tight that
it is causing the child any discomfort. It is recommended that there is just enough room to insert two fingers
between the shoulder straps and the child’s chest.
fig. 1
fig. 2
fig. 3
The harness has two positions. As your child grows you will need to
move the straps to the next slots.
The correct slots are those at, or just below your child’s shoulders. If
the slots are too far from the shoulders there will be too much slack.
To adjust the harness, remove each strap by passing it through the
slots from the front to the back of the seat. Re-route the straps
through the appropriate slots, as shown in the image above.
4
5
www.obaby.co.uk
www.obaby.co.uk