Summary of CT-2300 series
Page 1
1 ct-2300/ct-2400 series tripod you’re on steady ground ™.
Page 2: Introduction
2 thank you for choosing oben! Congratulations on your purchase of this sturdy, multi-featured oben ct-2300/2400 series tripod. It will deliver lightweight, rock-solid camera support for years to come. Adjusting the tripod’s height is simple: just loosen a twist-lock by turning it three-quarters of ...
Page 3: Table Of Contents
3 key features 5 leg length adjustment 6 leg angle adjustment 6 center column adjustment 7 low-angle setup 7 counterweight 9 mounting the head 9 retractable spiked feet 10 warnings 11 table of contents.
Page 4: Key Features
4 key features a e i j g d b c h k f.
Page 5: Key Features
5 key features a b k h i j f g e d c center column locking knob short split-column grooved reversible center column head locking screws leg angle adjustment lock twist-style leg lock levers bubble level all-terrain feet dual 3/8”-1/4”-20 head mounting screw strap mount retractable and removable weig...
Page 6: Operation
6 operation 2. Leg angle adjustment for stable support when shooting on uneven terrain, each leg of your tripod can be individually set at a preset angle of 24˚, 55˚ or 80˚. To change a leg’s angle, pull the adjustment lock outward and set the angle of the leg. Push the lock in to lock the leg at th...
Page 7: Operation
7 operation operation there are two ways to adjust the tripod for low-angle shots. Reverse the center column 1. Remove the built-in weight hook from the bottom of the column by turning it counterclockwise and pulling it out of the column. 3. Center column adjustment 4. Low-angle setup the sliding ce...
Page 8: Operation
8 operation 4. Low-angle setup 2. Turn the center column locking knob counterclockwise to unlock the center column. Remove the center column from the tripod. 3. Reverse the center column and insert it up the bottom of the tripod top plate. 4.Slide the column into the desired position. Turn the cente...
Page 9: Operation
9 operation 5. Counterweight when shooting under windy conditions or when using a telephoto lens, the stability of your camera is critical. The built-in spring-loaded hook at the bottom of the center column allows you to hang a counter- weight for increased stabilization, such as a (not included) sa...
Page 10: Operation
10 7. Retractable spiked feet* 6. Mounting the head a spike is built into each of the tripod’s rubber feet. The rubber non-skid feet are for use indoors or on flat surfaces, while the spikes are for soft ground, grass, sand, and on uneven terrain. To extend the spike, rotate the rubber pad at the bo...
Page 11: Optional Accessories
11 ! Warnings: • do not exceed the tripod’s maximum load capacity (see tag on tripod). • ensure that all appropriate locks are engaged when necessary. • tripod should only be used in temperatures between -22° and 140° fahrenheit. • do not operate in salt water. Dry tripod off if it becomes wet. • re...
Page 12
12 www.Obensupports.Com © cop yright 2014 the gr adus gr oup all o ther tr ademark s ar e the pr oper ty o f their r espec tiv e o wner s.