OBH Nordica 6972 User Manual - page 20
20
16. When the appliance is disconnected, always pull the plug,
never disconnect by pulling the cord.
17.
Caution: In order to avoid a hazard due to inadvertent re-
setting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility.
18. Always examine appliance, cord and plug for damage before
use. If the supply cord is damaged, it must be replaced by
the manufacturer, or his service agent or a similarly qualified
person in order to avoid a hazard.
19. For additional protection the installation of a residual current
device (RCD) with a rated residual operating current not ex-
ceeding 30 mA is recommended. Ask your installer for advice.
20. The appliance is for domestic use only.
21. If the appliance is used for other purposes than intended, or
is it not handled in accordance with the instruction manual,
the full responsibility for any consequences will rest with the
user. Any damages to the product or other things are not
covered by the warranty.
Before use
Before the waffle iron is used for the first time, read the instructions for use carefully
and save them for future use.
Unwind the cord. Clean the plates with a damp cloth and grease them with fat
before you use the appliance for the first time. The first 2 waffles should not be
eaten.
Use
Plug the appliance to an outlet, the red pilot lamp will light. Set the temperature
by turning the temperature knob to desired setting (1-6) . Setting 1 gives a low
temperature (lighter frying) and 6 a higher temperature (harder frying). We
recommend that you test different settings until you find the right one for your
personal taste. When the selected temperature is reached the green pilot lamp
will light and the appliance is ready for use.
6972_UL_UVN_041113.indd 20
11/4/2013 10:43:36 PM